What are the reasons behind poor pick-up of motor cycle, Mechanical Engineering

Assignment Help:

(a) Why does engine overheat and what will happen if engine overheats?

(b) Why engine does not start in wet or damp weather?

(c) What may be the causes if engine dose not start at cranking speed?

(d) Why does engine misfire?

(e) What are the reasons behind poor pick-up?

 


Related Discussions:- What are the reasons behind poor pick-up of motor cycle

Sada, Ask question #ccMinimum 100 words accepted#

Ask question #ccMinimum 100 words accepted#

Stress and strain, Draw and also explain the stress strain diagram for the ...

Draw and also explain the stress strain diagram for the following materials a) Copper b) Ductile Materials c) Rubbers and Elastomers and d) Brittle materials.

Lean mixture -mixture requirement , Lean Mixture: It generally ranges...

Lean Mixture: It generally ranges from approximately 15 : 1 to 17 : 1. By the use of this fuel, engine runs for higher economy.

Constant pressure cycle, Diesel (Constant Pressure Cycle): 5-1...

Diesel (Constant Pressure Cycle): 5-1 Suction Stroke at constant pressure 1-2 Adiabatic Compression 2-3 Heat Addition at constant pressure 3-4 Adiabatic Expan

Prove the bending equation, Can you give me the Prove of the bending Equati...

Can you give me the Prove of the bending Equation M/I=E/R=σ/Y

Loosening a part with multiple fasteners services tips, Loosening a Part wi...

Loosening a Part with Multiple Fasteners: Loosening a part with multiple fasteners should be done from the outside to inside in a criss-cross pattern, loosening the small fastener

Determine the ratio of the inlet pipe diameter, Air flows steadily at the r...

Air flows steadily at the rate of 0.5 kg/s through an air compressor, entering at 7m/s velocity, 100 kPa pressure, and 0.95 m 3 /kg volume, and leaving at 5 m/s, 700 kPa, and 0.19

Determine the cutting ratio, Write the velocity relationship in orthogonal ...

Write the velocity relationship in orthogonal cutting. A bar of 75 mm dia. is reduced to 73 mm by a cutting tool while cutting orthogonally. If the mean length of cut chip is 73.5

Support reaction and roller support, Support reaction: Explain the su...

Support reaction: Explain the support reaction? What are different types of support and their reactions? Sol.: When the numbers of forces are acting on a body, and the

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd