compressive strength, Mechanical Engineering

Assignment Help:
I have some plastic tube .5 OD .44 ID .5 long
I put them in a vise end to end (sealing the inside of the tube)
THen using a torque wench crush them to see when they fail. I get readings like 289 Ft LBS and lows of 150 Ft LBS
The thread on the vise is a 1" OD with 7 pitch thread
From this information can you tell the actual compressive strength of the tubes

Related Discussions:- compressive strength

Evaluate the net work done by the gas, An ideal gas is heated at fixed volu...

An ideal gas is heated at fixed volume until its temperature is 3 times the original temperature. It is then expanded isothermally till it reaches original pressure. The gas is t

Rigid joints, Solve the support reactions at A and D by using the force met...

Solve the support reactions at A and D by using the force method. A is a fixed support; B and C are rigid joints; and D is a pin support. EI is constant for all members.

Spring, strain energy = m2l/2Ei

strain energy = m2l/2Ei

Tension testing, The first laboratory report, covering the two-part exercis...

The first laboratory report, covering the two-part exercise involving tension testing and stress concentrations is due in lab two weeks after the conclusion of fatigue testing.

Determine shear plane angle, The following data was obtained from an orthog...

The following data was obtained from an orthogonal cutting test : Rake angle = 20o, Depth of cut = 6 mm Feed rate = 025 mm/rev Chip length before cutting = 29.4 mm Chip

Calculate the kic from the data - thick cylinder, Calculate the KIC from th...

Calculate the KIC from the data - thick cylinder: In a fracture test a 3-point bend specimen of thickness 20 mm and depth 25 mm is supported over a span of 100 mm. The specime

Design pumps for plant layout, Q. Design Pumps for plant layout? Pumps ...

Q. Design Pumps for plant layout? Pumps handling flammable or combustible materials are relatively frequent sources of leakage and should therefore be located as far as practic

Determine the heat addition, Describe carburetion. What are the basic diffe...

Describe carburetion. What are the basic different air-fuel mixture on which an engine can be operated ? Write a short note on sterling cycle. In an engine working on inlet pres

Evaluate the effects at certain instant, The turbine rotor of ship of mass ...

The turbine rotor of ship of mass 6000Kg has a r of Gyration 50cm. It moves at speed of 1820rpm clockwise when looking from the rear. Evaluate the effects set up:- 1) If the shi

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd