What are the hardware elements in the embedded systems, Electrical Engineering

Assignment Help:

What are the hardware elements in the embedded systems?

Hardware Elements in the Embedded Systems are as follows:

(i) Power Source

(ii) Clock Oscillator Circuit and Clocking Units

1. Suitable clock oscillator circuit

2. Real Time Clock (as System Clock)and Timers driving hardware and software

(iii) Reset Circuit

1. Reset onto Power-up

2. Internal and External Reset circuit

3. Reset onto Timeout of Watchdog timer

(iv) Memory

(v) Interrupts Handler

Interrupt Handling tool for the external port interrupts, input-output interrupts and RTC interrupts, timer and software interrupts and Exceptions

(vi)    Linking Embedded System Hardware

• Interfacing and Linking circuit for the Buses through using the suitable multiplexers, and decoders, demultiplexers Interface the several system units


Related Discussions:- What are the hardware elements in the embedded systems

Find the rated and maximum torques, A 4000-V, 5000-hp, 60-Hz, 12-pole synch...

A 4000-V, 5000-hp, 60-Hz, 12-pole synchronous motor, with a synchronous reactance of 4  per phase (based on cylindrical-rotor theory), is excited to produce unity power factor at

Slack running fit, Illustrate the conventional representations of the follo...

Illustrate the conventional representations of the following guide to the selection of Fits: (i) Slack Running Fit (ii) Loose Running Fit (iii) Easy Running Fit (iv) No

Compute the terminal voltage and current of each generator, Q. Three dc gen...

Q. Three dc generators are operating in parallel with excitations such that their external characteristics are almost straight lines over the working range with the following pairs

Calculate the rated load current of machine, A 500 MVA, 33kv, three phase s...

A 500 MVA, 33kv, three phase steam turbine generator has a synchronous reactance of 1.6 p.u. It delivers a rated output at 0.8 power factor lagging. Calculate (a) The synchronou

power sector economics & planning, 1.  The rejection criteria of an invest...

1.  The rejection criteria of an investment project, as evaluated from the NPV method is that NPV should be equal to zero. 2.  Technical feasibility is the only criteria to dete

Help assignments, A three-phase transposed line is composed of one conducto...

A three-phase transposed line is composed of one conductor per phase with flat horizontal spacing of 11 m as shown in Figure 1(a). The conductors have a diameter of 3.625 cm and a

Determine what is the minimum required sampling rate, 1. An analog informat...

1. An analog information signal, whose maximum frequency is 6000Hz, is to be transmitted using a PCM system. The quantization error must not exceed the 1 % of the peak-to- peak an

Positive and negative clippers, Positive Clippers The shunt connected p...

Positive Clippers The shunt connected positive clipper, in which the diode conducts for positive half cycle and hence, the output is a straight line. During the negative half c

Determine rc and resistance, Q. A silicon npn BJT is biased by the method s...

Q. A silicon npn BJT is biased by the method shown in Figure, with R E = 240 , R 2 = 3000 , and V CC = 24 V. The operating point corresponds to V BEQ = 0.8V, I BQ = 110 µA,

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd