WATER RESOURCES SYSTEM PLANNING AND MANAGEMENT, Civil Engineering

Assignment Help:

Two crops are grown on land of 20ha.The cost of raising crop 1 is 3unit/ha, while for crop 2 it is 1 unit/ha.The benefit from crop 1 is 5unit/ha and from crop 2, it is 2 unit/ha. A total of 300 units of money is available for raising both crops. What should be the the cropping plan inorder to maximize the total net benefits?

Related Discussions:- WATER RESOURCES SYSTEM PLANNING AND MANAGEMENT

Recognize the losses of prestress, Recognize the losses of prestress Re...

Recognize the losses of prestress Recognising the losses of prestress which take place after the prestressing OF concrete structural elements, it is to be appreciated that pres

Mechanics, define structure?

define structure?

Determine the Critical Euler Buckling Load, a) Determine the critical Eule...

a) Determine the critical Euler buckling load of a solid aluminium rod of 12 mm diameter if it has a length of 1.0 m between pin-ended supports. (E = 70000 N/mm2) b) A

WATER SUPPLY, THE DESIGN PERIOD AVERAGE DAILY DEMAND CALCULATE. THE DESIGN ...

THE DESIGN PERIOD AVERAGE DAILY DEMAND CALCULATE. THE DESIGN DEMAND FOR THE WATER RETICULATION OR DISTRIBUTION PERIOD.

One layered spatial structures, Classification of the damage according to t...

Classification of the damage according to the type of structures The level of damage in spatial trusses has also been classified into three different levels based on th

Asphalt mix design – durability and stability, Q. Asphalt mix design - dura...

Q. Asphalt mix design - durability vs. stability? The main aim of asphalt mix design is to achieve a mix with economical blending of aggregates with asphalt to achieve the foll

Jacking face for pipe-jacking, Ground settlement occurs ahead or behind the...

Ground settlement occurs ahead or behind the jacking face for pipe-jacking? It's reported by Lake (1992) that settlements are expected at ground surface at a distance of 1-2 ti

Example for beam flexure design, Example for Beam Flexure Design Select...

Example for Beam Flexure Design Select the lightest W section for the simply supported beam shown below. The beam length is 12ft. The nominal loading is: w d = 4.0 kip/ft (i

Project costing for Engineering success, Hi I am looking for someone who ca...

Hi I am looking for someone who can help to solve my assignment questions in a subject called project costing and I need him to continue with me until I complete this subject. I a

Use plain dumb-bell type and center-bulb sort, Question While selection...

Question While selection of waterstop, shall engineers use plain dumb-bell type , center-bulb sort ? Answer Plain dumb-bell kind is used for joint site where sm

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages