Water absorption test for precast concrete pipes, Civil Engineering

Assignment Help:

Question

What is the major purpose of carrying out water absorption test for precast concrete pipes?

Answer

Cement will mix with additional water than is compulsory to eventually combine through hydration of cement paste. As, some voids will be left at the back after hydration process that affects strength and durability of concrete. With being there of air invalid in concrete, it is vulnerable to diffusion and attack by aggressive chemicals. High-quality concrete is measured by having minimal voids left by overload water and so, water absorption test for precast concrete pipes is accepted for checking quality of concrete in terms of thickness and invulnerability.

 


Related Discussions:- Water absorption test for precast concrete pipes

Inspection and quality control certificate, Q. Inspection and Quality Contr...

Q. Inspection and Quality Control Certificate : A 'lot' under inspection should be accepted by the inspector when no defect is found in the acceptance level tests and so certif

Convert reduced bearings into whole circle bearings, Example: Convert t...

Example: Convert the following reduced bearings into whole circle bearings: (i) N 65° E                           (ii) S 43° 15′ E (iii) S 52° 30′ W           (iv)

Water transportation, Water Transportation: Water transport, in its va...

Water Transportation: Water transport, in its various forms, is one of the most efficient forms of transport, because of low fuel consumption, low environmental pollution and

Concrete mixers, what do you mean by buttering mixers

what do you mean by buttering mixers

Calculate the cost to finance the construction project, A contractor is bid...

A contractor is bidding a construction project that will take 12 months to complete. The terms of the bid provide that the owner will pay the Contractor one lump sum at the end of

Define categories of spalls -underwater inspection of bridge, Define catego...

Define categories of Spalls -underwater inspection of bridge? Spalls are classified as follows:  i. Small spalls - up to 25 mm deep or approximately 150 mm in diameter. i

Find the size of the foundation required, A steam turbine with base 6 m × 3...

A steam turbine with base 6 m × 3.6 m weighs 10,000 kN. It is to be placed on a clay soil with c = 135 kN/m 2 . Find the size of the foundation needed if the factor of safety is to

Concrete, What is Under vibration of fresh concrete?

What is Under vibration of fresh concrete?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd