Various components of transmission system , Mechanical Engineering

Assignment Help:

Various Components of Transmission System

Primary Drive Gear : It is mounted on crankshaft. It transfers power to primary driven gear.
Primary Driven Gear : It is an integral part of the clutch outer body. It is mounted on the driving shaft of the clutch.
Clutch : The driven plate of the clutch is mounted on the gear box main shaft. The clutch connects or disconnects the engine crank shaft with the main shaft of the gear box.
The gears are mounted on both the main and counter shafts of the gear box.
The Drive Chain finally transmits power to rear wheel from counter shaft of the gear box.

Related Discussions:- Various components of transmission system

Predictive control algorithms, Predictive Control Algorithms Escaping S...

Predictive Control Algorithms Escaping Scheduling Errors via Partial Look-ahead Since previously mentioned above, the heuristic priority rules that are normally utilized in

Explain the zeroth law of thermodynamics, (a) Describe and explain the Zero...

(a) Describe and explain the Zeroth law of thermodynamics. Why it is so called ? What is understand by fixed points of a thermometric scale ? (b) In what respects are the work a

Solid modeling and design, You are an engineer for WhyShopHere Toys. You ha...

You are an engineer for WhyShopHere Toys. You have been tasked with the following: Design a child's toy to provide food for fish in an aquarium. The toy should take the fo

Tensile strain, T ensil e Strain: When the tensile load acts on body...

T ensil e Strain: When the tensile load acts on body then there will be decrease in cross sectional area and an increase in length of body. The ratio of increase in length t

PUMP, We have a reciprocating compressor operating at 800 rpm. Suction pre...

We have a reciprocating compressor operating at 800 rpm. Suction pressure and discharge pressure are held constant by other systems that have nothing to do with the compressor. W

Capp for machining process, CAPP for Machining Process This explained ...

CAPP for Machining Process This explained mainly two different approaches to Computer Aided Process Planning, i.e. (a) Variant approach, and (b) Generative approach.

#tittle thrumo , ES 347 - Thermodynamics Project Assigned: 3/28/2013 Due: 4...

ES 347 - Thermodynamics Project Assigned: 3/28/2013 Due: 4/25/2013 Problem specification 5 kg of air is contained in a piston-cylinder device, initially at a pressure of 2MPa and a

Natural frequency-degree of freedom-conservative system , Natural Frequency...

Natural Frequency: This is the frequency of vibration of a system that is undamped and without external excitation while it is disturbed. Forced Vibration: This is the vibra

Stud welding, Stud Welding This is an arc welding process in which the...

Stud Welding This is an arc welding process in which the arc is struck between a metal stud or similar part and the base metal. The arc heats the mating ends to a proper tempe

Explain external pressure design, Q. Explain External Pressure Design? ...

Q. Explain External Pressure Design? Determine requirements for external pressure based on the expected operation of the vessel, and add a suitable operating margin to establis

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages