transmission line, Electrical Engineering

Assignment Help:
A three-phase transposed line is composed of one ACSR conductor per phase with flat horizontal spacing of 11 meters as shown in Figure (a). The conductors have a diameter of 3.625 cm. The line is to be replaced by a three-conductor bundle of ACSR. Each conductor of bundle is having the same diameter as the single-conductor line. The new line will also have a flat horizontal configuration, but it is to be operated at a higher voltage and therefore the phase spacing is increased to 14 m as measured from the center of the bundles as shown in Figure (b). The spacing between the conductors in the bundle is 45 cm. Determine
(a) The percentage change in the inductance.
(b) The percentage change in the capacitance.

Related Discussions:- transmission line

Define transconductance, Q. Define Transconductance? The control that t...

Q. Define Transconductance? The control that the gate voltage has over the drain current is measured by the transconductance gfs and is similar to the transconductance  gm of t

Determine the equivalent inductance, Determine the equivalent inductance: ...

Determine the equivalent inductance: Two coils of inductances 4H and 6H are connected in parallel. If their mutual inductance is 3 H, determine the equivalent inductance of th

Factors contributing to high technical losses, Factors Contributing To High...

Factors Contributing To High Technical Losses Power distribution systems in developing countries have faced a phenomenal and rapid growth within the last two decades. Although

Applied electronics, What is coupling? Explain the types of coupling

What is coupling? Explain the types of coupling

Engineering drawing, connect two given points A and B by a parabolic curve ...

connect two given points A and B by a parabolic curve when OA=60mm,OB=80mm and angle AOB=110 degree

Find the thevenin equivalent, Task 1 Use basic circuit theory to...

Task 1 Use basic circuit theory to convert the "T" circuit below into the equivalent "π". Hint: Remember to disconnect the voltage source and the load. Task 2

Define the term assembler directives, Define the term assembler directives....

Define the term assembler directives. An assembler directive is a statement to provide direction to the assembler to perform the function of assembly process. The assembler di

Analyze diode circuit with rlc load, Q. Analyze Diode circuit with RLC load...

Q. Analyze Diode circuit with RLC load? Consider a diode circuit with an RLC load, as shown in Figure, and analyze it for i(t) when the switch S is closed at t = 0. Treat the d

Explain balanced wye-connected load, Balanced Wye-Connected Load Let us...

Balanced Wye-Connected Load Let us consider a three-phase, four-wire 208-V supply system connected to a balanced wye connected load with an impedance of 10 20° , as shown in F

Obtain the truth table for the logic block, Q. Obtain the truth table for t...

Q. Obtain the truth table for the logic block shown in Figure

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd