Transformer question, Electrical Engineering

Assignment Help:
When I read the details of how a transformer works and apply those rules to a transformer where the primary core cross-sectional area is twice that of the secondary, I come up with impossible efficiencies over 100%. What am I doing wrong?

Related Discussions:- Transformer question

What do you understand by analog to digital conversion, Q. What do you unde...

Q. What do you understand by Analog to Digital conversion? What do you understand by A/D conversion? Give an explanation of any one of the following A/D techniques: (i) Su

Determine the ratio of full-load current, The rotor of a wound-rotor induct...

The rotor of a wound-rotor induction motor is rewound with twice the number of its original turns,with a cross-sectional area of the conductor in each turn of one-half the original

Explain acceptance cone, Explain Acceptance cone? The fibre air - core ...

Explain Acceptance cone? The fibre air - core interface is display below: In this figure Omax is the maximum angle, inside that the rays undergo total internal reflecti

Permeability and b-h curve for different magnetic materials, Permeability a...

Permeability and B-H curve for different magnetic materials Permeability is the ability of a magnetic circuit to create magnetic flux lines in a material or substance that prod

Explain digital control systems, Q. Explain Digital control systems? Si...

Q. Explain Digital control systems? Significant progress has been made in recent years in discrete-data and digital control systems because of the advancesmade in digital compu

Electric helicopter, examples in building electric helicopter using cardboa...

examples in building electric helicopter using cardboard, balsa wood, scotch tape, glue, binder clips, rubber bands, rubber stoppers, etc. attached to a 12v power supply

ELECTRO MAGNETIC INDUCTION, If aluminium and copper pipes are of same lengt...

If aluminium and copper pipes are of same length and diameter ... same magnet dropped through them...in copper it takes more time to come out of other end, i myself have done this.

Commercial losses in electrical systems, Commercial Losses in Electrical Sy...

Commercial Losses in Electrical Systems Commercial losses are caused by pilferage, theft, defective meters, and errors in meter reading and in estimating un-metered supply of

Transparent latch d flip flop, Transparent latch D flip  Flop A typica...

Transparent latch D flip  Flop A typical  example  of this  type of D flop  is 7475 shown  in figure when CLK  connected is enable signal is high and the flip  flop  is enabled

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd