Branch operations , Electrical Engineering

Assignment Help:

Branch Operations

Normally  the program  executes in  a sequence. The contents of the program counter register are incremented by  one during  the execution  of current  instruction and  always  points to the  next instruction to be executed.

Sometimes it is  required to change  the normal  the normal  sequence of the program.  The branch  instruction are used to  change  the normal  sequence o f the program  various  branch  instructions ( jump call  return restart )  are explained below.


Related Discussions:- Branch operations

What is the per-unit slip at full load, Q. A three-phase, 60-Hz induction m...

Q. A three-phase, 60-Hz induction motor runs at almost 1800 r/min at no load, and at 1710 r/min at full load. (a) How many poles does the motor have? (b) What is the per-unit

Which stack is used in 8085, LIFO (Last In First Out) stack is used in 8085...

LIFO (Last In First Out) stack is used in 8085.In this type of Stack the last kept information can be retrieved first.

Determine the voltage gain , (a) A second order Sallen and Key Low Pass Act...

(a) A second order Sallen and Key Low Pass Active Filter has these component values R 1 =R 2 =15 kΩ, C 1 =C 2 =1 nF and the feedback resistors are R 3 =3.9 kΩ and R 4 =2.3 kΩ

Three byte instruction , Three byte instruction The  instruction which...

Three byte instruction The  instruction which  have 16  bit data address  as its  operand  are three byte  instruction. They  need three  memory  locations to store  them in m

Residential wiring and safety considerations, Q. Residential wiring and saf...

Q. Residential wiring and safety considerations? Residential electric power service commonly consists of a three-wire ac system supplied by the local power company. A distribut

Synchronization, Synchronization:  Whatever type of weep is used, it must ...

Synchronization:  Whatever type of weep is used, it must be synchronized with the signal being measured. Synchronization has to be done to obtain a stationary pattern. This requir

Plc and control system analysis, The assignment is to plan, design and writ...

The assignment is to plan, design and write a PLC program on the FX Training Software using a PART SUPPLY CONTROL SYSTEM based on the requirement specification outlined be

Microprocessor, Memory map of tpa in a personal computer and explain such o...

Memory map of tpa in a personal computer and explain such of the areas in brief

Image gradient, Image gradient Write an m-file "grad.m" which computes ...

Image gradient Write an m-file "grad.m" which computes and displays gradient and orientation of an input image (use Gaussian derivatives). To compute Gaussian derivative in o

Device switching losses and snubbers, May I know if your site can help me w...

May I know if your site can help me with design a snubber and model the circuit using LTSpice software?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd