Tensile strain, Mechanical Engineering

Assignment Help:

Tensile Strain:

When the tensile load acts on body then there will be decrease in cross sectional area and an increase in length of body. The ratio of increase in length to original length is called as tensile strain.

et  δL/L

 

1988_Tensile Strain.png

The strain is caused in the direction of application of load is called as longitudinal strain. Another term lateral strain is strain in direction perpendicular to the application of load that is, δD/D

 

 

 


Related Discussions:- Tensile strain

What are the constructional aspects of well foundations, What are the Const...

What are the Constructional Aspects of Well Foundations  There are several aspects which require careful consideration during sinking of well foundations. They are i)  Prepa

Explain ericsson cycle, (a) Write short note on following : (i) Ericsson...

(a) Write short note on following : (i) Ericsson cycle (ii) Diesel cycle (iii) Stirling cycle (b) The swept volume of a diesel cycle engine working on dual cycle is 0.0

Material and tribology, The Cu-Sb system contains 2 eutectics, 1 eutectoid,...

The Cu-Sb system contains 2 eutectics, 1 eutectoid, 1 peritectic and 1 peritectoid. Mark them all on the figure, write down the temperature and composition of each point, and ident

Minimun work term in reciprocating compressor, what is mean by minimum work...

what is mean by minimum work term in reciprocating compressor?

Compound stress, Compound Stress: Define Compound Stress. Sol.: ...

Compound Stress: Define Compound Stress. Sol.:   Simple stresses mean tensile stress or compressive stress or shear stress. The tensile and compressive stresses act on p

Computational mechanics in design, Figure shows an impression of one of man...

Figure shows an impression of one of many lifting arrangements produced and used at a steel fabrication workshop. It was manufactured to lift a maximum of 50 kg and due to a produc

Power plants, explain different power plants..???

explain different power plants..???

Explain tee joints, Tee joints -The square tee joint requires a fillet weld...

Tee joints -The square tee joint requires a fillet weld that can be made on one or both sides. It can be used for light or fairly thick materials. For maximum strength, considerabl

Dryness fraction of steam - thermodynamics, Drynes s Fraction of Steam: ...

Drynes s Fraction of Steam: Dryness fraction of steam is factor which used to specify the quality of steam. It can be defined as the ratio of weight of dry steam W d s pr

Klein construction, how to find acceleration by Klein construction

how to find acceleration by Klein construction

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd