Tensile and compressive force - mechanics, Mechanical Engineering

Assignment Help:

Tensile and Compressive Force:

Tensile Forces

A force, that pulls the body, is called as tensile force. Here member AB is tension member carrying tensile force P. As shown in the figure given below.

Compressive Force

A force, which pushes the body, is called as compressive force shown in figure given beow

 

398_Tensile and Compressive Force.png

 


Related Discussions:- Tensile and compressive force - mechanics

Evaluate cross-section of leaves, A semi-elliptic multi-leaf spring is need...

A semi-elliptic multi-leaf spring is needed for the suspension of the rear axle of a truck. It consists of two extra full-length leaves and ten graduated length leaves including th

What are the technical limitations of screw conveyer, What are the Technica...

What are the Technical Limitations of screw conveyer Technical Limitations: ? Turning limitation of this mechanism Actually the Maximum Turning of U-joint is 18° to 2

Define the process of step community, Define the process of STEP community ...

Define the process of STEP community The STEP community is in the process of defining and standardizing a number of domain-specific (mechanical or electrical) Application Proto

Air transportation, AIR TRANSPORTATION: Air transportation has grown r...

AIR TRANSPORTATION: Air transportation has grown rapidly all over the world and in India too. Its main advantages are speed, good safety record, military use, ability to serve

Air-gas cross-limiting and air-gas ratio control, Q. Air-Gas Cross-Limiting...

Q. Air-Gas Cross-Limiting and Air-Gas Ratio Control? The Steam Generator firing demand signal is directed to two discrete signal selectors. A low signal selector ensures that

Longitudinal stress in the plate section through the rivets, A steam boiler...

A steam boiler, 3 m in diameter, is made of 25 mm thick mild steel plates. The efficiency of longitudinal riveted joint is 88% and that of circumferential riveted joint is 70%. Cal

Flue gas excess oxygen control for steam generator, Q. Flue Gas Excess Oxyg...

Q. Flue Gas Excess Oxygen Control for steam generator? Air-gas ratio control provides approximate excess oxygen control. However, an in-situ oxygen probe measures the actual o

Chassis lubrication system, Chassis Lubrication System : This lubrication ...

Chassis Lubrication System : This lubrication system consists of outer body parts, which are lubricated from outside of the body. Table of Lubrication Points Sl.

Show material selection process, Q. Show Material selection process? • ...

Q. Show Material selection process? • Design life shall be based on project design criteria and normally 10 to 15 years' service life specified for well pads, 20-25 years for C

What is forced draft fan, Q. What is Forced Draft Fan? Fan shall comply...

Q. What is Forced Draft Fan? Fan shall comply with API 673 as supplemented by the following: (para. references are to API 673). Where the intake air is unfiltered, the Vendo

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd