Subcontractor submittals, Mechanical Engineering

Assignment Help:

The Supplier/Subcontractor shall submit, for acceptance, their Material Traceability and PMI program and procedures, which shall comply with this specification, prior to the sourcing of materials or construction. The PMI Program shall include the requirements and responsibilities for controlling inspection, measuring and test equipment (IM&TE), including calibration, recall and maintenance to demonstrate conformance of work activities to the specified requirements. The qualifications, training and experience of the operator(s) shall also be included. The Purchaser reserves the right to audit the Program to ensure compliance and verify competency of operators. Non-adjustable measuring and test equipment is not considered as calibrated equipment. Equipment of this nature (e.g. cube and proctor moulds, measuring tapes, rulers, chains) is subject to a "conformance check" to dimensional, volumetric or other measurements and does not require any further verification unless apparent damage or other factors require re-verification.


Related Discussions:- Subcontractor submittals

Need of a spectrophotometer, Need of a spectrophotometer: The specific...

Need of a spectrophotometer: The specific instructions will differ with other models, but the principles remain. 1. The instrument must have been warm for at least 15 min.

Determine elongation of bar, Determine elongation of bar: A conical b...

Determine elongation of bar: A conical bar tapers uniformly from diameter of 4 cm to 1.5 cm in length of 40 cm. If axial force of 80 kN is applied at each end, determine elon

Slab hanging - mechanics, Slab hanging: Three similar uniform slabs ...

Slab hanging: Three similar uniform slabs each having length '2 a ' are resting on edge of table as shown in the figure given below. If each slab is overhung by the maximum

Applications of seam welding, Applications of seam welding Lap seam wel...

Applications of seam welding Lap seam welding is used for the manufacture of cans, buckets and water tanks and for welding thin walled large diameter pipes. Mash seam welding

Simple single machine system, Consider a simple single machine system. It c...

Consider a simple single machine system. It consists of workpieces that enter the system, wait their turn to be processed on a single machine, and then depart the system. The workp

Determine the stability of the closed loop system, Determine the stability ...

Determine the stability of the closed loop system whose open loop transfer function is Use the Nyquist criterion

If no leak found in the above listed area remove flywheel, If no leak found...

If no leak found in the above listed area remove flywheel: Remove fly wheel and check weather oil leak is from the seal or "o" ring.

Battery components , Cell Connectors A cell connector connects the ne...

Cell Connectors A cell connector connects the nearby cell with two terminals of opposite polarity (sign). Post strap connect the plates to the terminal. Electrolyte

Objectives of motorcycle servicing , Objectives After studyingmotercyc...

Objectives After studyingmotercycle servicing, you should be able to appreciate the importance of regular servicing and maintenance of a motorcycle and also to recommen

Vicker''s hardness test, V icke r ' s Hardness Test: This test is ...

V icke r ' s Hardness Test: This test is alike the Brinell test but uses different indenter. A square based pyramid of cone angle 136 ° is used. The applied load can be 5,

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd