Bund and dike capacity, Mechanical Engineering

Assignment Help:

Bund / dike capacity is typically covered by local codes and regulations, however some general principles for liquid storage compounds are:

• The net capacity of a bunded / diked compound in a storage facility must be at least 120% of the net capacity of the largest tank. Take into consideration the capacity displaced by other tanks within the same bunded / diked area and any foundations. Treat interconnected tanks as a single tank of equivalent total volume.

• For flammable liquids, bund / dike capacity should be at least 133% of the net capacity of the largest tank. If an automatic fire sprinkler system is installed in or over any bunded / diked tank or drum storage compound, the capacity of the bund / dike should be increased either by a volume equal to the output from the sprinkler system for a period of at least 20 minutes, or to 133% of the capacity of the largest tank, whichever is greater.


Related Discussions:- Bund and dike capacity

Alignment of piping flanges, Q. Alignment of piping flanges? Alignment ...

Q. Alignment of piping flanges? Alignment of piping flanges shall be in accordance with ASME B16.5. This code specifies that: • Flange centerline misalignment must be within

Calculate the spindle speed in milling operation, Calculate the Spindle Spe...

Calculate the Spindle Speed in Milling Operation Calculate the spindle speed (N) if a copper job is to be milled by  (a) stellite cutter  (b) cemented carbide cutter.

Manufacturing methods of ceramics, Manufacturing Methods Of Ceramics Th...

Manufacturing Methods Of Ceramics The ceramics manufacturing consists in shaping along with or without pressure and firing to consolidate. The simplest and cheapest process of

Entropy, What is entropy microscopically

What is entropy microscopically

Governors, how to find mass of sleeve in porter governor

how to find mass of sleeve in porter governor

Electric discharge phenomenon, ELECTRIC DISCHARGE PHENOMENON The flow of ...

ELECTRIC DISCHARGE PHENOMENON The flow of electricity through metallic solids, or through liquid metals is called Conduction. The electricity  flow through ionic solutions

Determine the minimum acceptable diameter of the shaft, The Shaft is made o...

The Shaft is made of a material with an allowable shear strength of 80 Mpa. a.       Develop the torque diagram b.      Determine the minimum acceptable diameter of the shaft

Finite Element Analysis of Pressure Vessel, Need a basic explanation of how...

Need a basic explanation of how to go about doing a plane strain analysis of a pressure vessel

Material selection for insulation in personnel protection, Q. Material Sele...

Q. Material Selection for Insulation in Personnel Protection? Material for 15ºC to 650ºC temp range is Calcium Silicate (ASTM C533, Type 1), Manville Thermo-12 or approved equi

Piston leaves the bottom stops , Consider the frictionless piston-cylinder ...

Consider the frictionless piston-cylinder set-up with a linear spring as is shown below. The cylinder has an internal cross-sectional area of AC = 0.1 m2. Distances  y 1 and  y 4

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd