How can we transfer data among cad system, Mechanical Engineering

Assignment Help:

How can we transfer data among CAD system

The three main reasons for transferring data among CAD systems (or CAE systems or agents etc.) are :

(i)  To communicate with remote computers and design workstations. Practical limitations, such as shortage of workstations, can already lead to storage/retrieval and interchange of CAD models.

(ii)  Long-duration storage and retrieval, and archival purposes.

(iii)  During the design process, a CAD system may turn out to be incapable of performing the required modeling operations. Then it can be decided to send the CAD model to a different CAD system which does have the required functionality.

 


Related Discussions:- How can we transfer data among cad system

What will be the alteration of pressure, A copper tube 1.2 m long, has 80mm...

A copper tube 1.2 m long, has 80mm internal diameter and 2 mm wall thickness. It has closed ends, and is filled with water under pressure. What will be the alteration of pressure i

Hazardous waste and material standards, Hazardous Waste and Material Standa...

Hazardous Waste and Material Standards Each hazardous site must be examined and evaluated for its characteristics before workers are allowed entry. This will pre decide an

Newtons third law, Problem - Newton's Third Law Newton's Third Law of M...

Problem - Newton's Third Law Newton's Third Law of Motion states that if two objects interact, the force F 12 exerted by object 1 on object 2 is equal in magnitude and oppos

What is plain concrete footing, What is Plain Concrete Footing? Plain C...

What is Plain Concrete Footing? Plain Concrete Footing: Footings carrying relatively light loads are constructed with plain concrete. You have already seen a plain concrete

Rotational-mechanics, A straight rod of length L is released on a friction ...

A straight rod of length L is released on a friction less horizontal floor in a vertical position . As it falls( also slips) , the distance of a point on the rod from the lower end

Cyclic service for vessels, when does the cyclic service apply for pressure...

when does the cyclic service apply for pressure vessels in batch plant (operation)

Explain about the pedestals as construction engineering, Explain about the ...

Explain about the pedestals as construction engineering. Introduction of pedestals enables the construction engineers to make up levels to supply larger bearing areas to the fo

Plate clutch movement on center clutch-clutch jerking, Plate clutch movemen...

Plate clutch movement on center clutch : Place plate clutch on centre clutch as shown in the picture and move the plate clutch up and down, while moving the plate clutch in the ce

Explain the advantages of rack cutter, Explain the Advantages of Rack Cutte...

Explain the Advantages of Rack Cutter? a. A single cutter of any specific pitch can cut gears of any number of teeth having similar pitch. b. The tooth profile produced is m

Calculate the diameter of the single pipe, a) Three pipes of lengths 800m, ...

a) Three pipes of lengths 800m, 400m, 500m and of diameter 500mm, 400mm and 300mm respectively are connected in series. Pipes are to be removed by a single pipe of length 1700m. Ca

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd