Squeeze castings, Electrical Engineering

Assignment Help:

Squeeze Castings:

Squeeze casting, also known as liquid metal forging, is a combination of casting and forging process .

The molten metal is poured into the bottom half of the pre-heated die. As the metal starts solidifying, the upper half closes the die and applies pressure during the solidification process. The amount of pressure thus applied is significantly less than used in forging and parts of great detail can be produced. Coring can be used with this process to form holes and recesses. The porosity is low and the mechanical properties are improved.


Related Discussions:- Squeeze castings

Calculate the supply line current, A balanced star-connected load is connec...

A balanced star-connected load is connected across a three phase 450V 50 Hz AC supply. Each load element has an impedance of 5+j12 Ω. Calculate: (i)  The power factor of the

Pnp bipolar junction transistor, PNP The other kind of BJT is the PNP ...

PNP The other kind of BJT is the PNP with the letters "P" and "N" standing for the majority charge carriers inside the dissimilar regions of the transistor. Figure:

Revenue loss due to loss of opportunity to serve, Revenue Loss Due to Loss ...

Revenue Loss Due to Loss of Opportunity to Serve The revenue loss because of "loss of opportunity to serve" is a extremely relevant but less visible aspect of revenue loss. Gu

Zener diode, how does a zener diode works

how does a zener diode works

Fabrication and testing laboratory, You will manufacture composite beams us...

You will manufacture composite beams using an epoxy matrix (West Systems 105 epoxy resin + West Systems 206 slow hardener) and one of the following reinforcements:  1.  Unidirec

Types of cells and batteries, Types of cells and batteries are:- a.  C...

Types of cells and batteries are:- a.  Carbon-zinc cell b. Nickel-cadmium cell c.  Alkaline celld.  d.  Edison cell e.  Mercury cell

Op code format , Op code Format As we  have seen  in the  section that...

Op code Format As we  have seen  in the  section that  the first  byte of all the instruction is the  op code. microprocessors  reads this  op code  and decodes it  to identif

Determine the bandwidth required for transmission, 1. A PCM system uses 8 b...

1. A PCM system uses 8 bits per sample and the analog signal is limited to 4.3 kHz. The PCM data is transmitted using (a) BFSK and (b) ASK. Determine the bandwidth required for tra

Redraw the wheat stone bridge circuit, Redraw the Wheat stone bridge circui...

Redraw the Wheat stone bridge circuit of Figure and show that Equation holds good for the null condition when the meter A reads zero current.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd