Preliminary stress analysis, Mechanical Engineering

Assignment Help:

Preliminary stress analysis work will start early in the detail engineering phase after completion of equipment layout and piping study drawings. The piping required to be analyzed will be divided into systems or sub-systems with logical break points and the Mechanical Engineer will provide the stress analyst with a preliminary information package for each piping system identified as requiring stress analysis.

Some of the critical piping systems are such that any changes in vendor information or equipment layout will result in considerable rework for the stress analyst and changes in piping layout. For other piping, preliminary analysis can be carried out without information from equipment vendors and any rework due to changes in layout or equipment details will not result in significant rework. The mechanical engineer, piping design and stress analyst will work out a schedule so that piping design, stress analysis and structural/foundation work for pipe support can proceed smoothly with minimum rework. While the sequence of work will vary from one project to another, the following general suggestions have been found useful in the past.


Related Discussions:- Preliminary stress analysis

what do you mean by ignition system?, (a) What do you mean by ignition sys...

(a) What do you mean by ignition system? Write down its functions. (b) Briefly describe the working principle of ignition system. (c) How is energy generated inside the batte

Ladder slip, ladder slip: A uniform ladder having length of 7m rests ...

ladder slip: A uniform ladder having length of 7m rests against vertical wall with which it makes an angle of 45º, coefficient of friction between ladder and wall is 0.4 and

Gasket installation in module site installation, Q. Gasket Installation in ...

Q. Gasket Installation in Module site installation? Gasket will be installed after modules are set. Normally RTJ flanges require mating flanges to be spread with jacks and then

What do you mean by filler metals, Q. What do you mean by Filler metals? ...

Q. What do you mean by Filler metals? Use filler metal that is similar in chemistry, corrosion resistance, and mechanical properties of the base metal being welded. Filler m

Calculate all the mass-normalised modal vectors, The body, suspension and e...

The body, suspension and engine mounting system of a vehicle may be idealised as a three degree of freedom system consisting of a bar of mass 1400 kg and the centre of mass at G, 1

Sound waves in gases, Sound Waves in Gases Sound waves are longitudinal...

Sound Waves in Gases Sound waves are longitudinal pressure waves. Let us consider the motion of a plane sound wave moving along  X-axis  in a gas medium. In undisturbed positio

Cast al alloys, Cast Al Alloys Low melting temperature, good surface f...

Cast Al Alloys Low melting temperature, good surface finish and insolubility to gases except H 2 are characteristics of these alloys. Significant drawback of cast aluminium a

Combustion chamber and radiant section, Q. Combustion Chamber and Radiant S...

Q. Combustion Chamber and Radiant Section? The combustion chamber and the radiant heat transfer section of the Steam Generators shall be a horizontal, multiple pass arrangement

Define advantage and disadvantage of electron beam machining, Define Advant...

Define Advantage and Disadvantage of Electron Beam Machining Advantage  1. Suitable for automatic machining. 2. Absence of mechanical contact between work piece and too

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd