Nominal stress and true stress, Mechanical Engineering

Assignment Help:

Nominal Stress and True Stress:

Nominal stress is the ratio of force per initial cross sectional area (original area of cross section).

Nominal stress = Force / initial area of cross-section  =  P / A0

True stress is ratio of force per actual cross sectional area taking lateral strain into consideration.

True stress = Force / Actual area of cross-section = P /A


Related Discussions:- Nominal stress and true stress

Calculate force required for equilibrium, Calculate force required for equi...

Calculate force required for equilibrium: A member ABCD is subjected to the point loads P 1 , P 2 , P 3   an d P 4   as shown in the figure given below

Determine the angle of twist - solid steel shaft, Determine the angle of tw...

Determine the angle of twist - solid steel shaft: A solid steel shaft 6 m long is fixed at each of the end. A torque of 3 kN-m is applied to the shaft at a section 2 m from on

Material selection for insulation in personnel protection, Q. Material Sele...

Q. Material Selection for Insulation in Personnel Protection? Material for 15ºC to 650ºC temp range is Calcium Silicate (ASTM C533, Type 1), Manville Thermo-12 or approved equi

Program evaluation and review techniques, Program Evaluation and Review Tec...

Program Evaluation and Review Techniques: The Rola and Cola Corporation is a professional II nursing home aspiring to become I nursing home. It desires to provide the ultimate

Estimate the viscosity of this diluted , A diluted polymer solution with a ...

A diluted polymer solution with a density of 1130 kg/m3 was extruded through a capillary tube of 3.5 mm internal diameter and 1 m long. The following results were obtained at 25°C.

Economic order quantity, Economic Order Quantity: Assume an economic o...

Economic Order Quantity: Assume an economic order quantity case where annual demand D = 500 units, economic order quantity Q = 100 units, the wanted probability of not stockin

Wilson hartnell governor, how to design and fabricate wilson hartnell gover...

how to design and fabricate wilson hartnell governor?

Calculate the probable wall thickness of the tank, The background for the o...

The background for the oil storage tank failure is as follows: the tank involved was a four million gallon circular tank that was built in 1940 for Ashland Oil Company in Cleveland

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd