mobile communication, Electrical Engineering

Assignment Help:
#qConsider a point-to-point radio link between two highly directional antennas in a stationary
environment. The antennas have antenna gains of 30 dB, distance attenuation is 150 dB, and
the RX has a noise ?gure of 7 dB. The symbol rate is 20 Msymb/s and Nyquist signaling is
used. It can be assumed that the radio link can be treated as an AWGN channel without fading.
How much transmit power is required (disregarding power losses at TX and RX ends) for a
maximum BER of 10
-5
:uestion..

Related Discussions:- mobile communication

Draw the circuit of a 7805 voltage regulator, Q. Draw the circuit of a 7805...

Q. Draw the circuit of a 7805 voltage regulator? Explain the functions of the capacitors used at its input and output sides. Functions of capacitors used at input and outp

Determine the voltage gain , (a) A second order Sallen and Key Low Pass Act...

(a) A second order Sallen and Key Low Pass Active Filter has these component values R 1 =R 2 =15 kΩ, C 1 =C 2 =1 nF and the feedback resistors are R 3 =3.9 kΩ and R 4 =2.3 kΩ

Transformers, Three transformers are provided with the following rating val...

Three transformers are provided with the following rating values: 1) 2400/240 V, 55kVA, Req1 = (0.1 + 0.0Y) Ohm and Xeq1 = (0.15 + 0.XX) Ohm. 2) 240/120 V, 25kVA, Req1 = (0.1

Pre-processing requirements - cpld design project , The pre-processing unit...

The pre-processing unit is responsible for taking the conditioned output from the heart sensor and generating a binary count during time T1 of this waveform (datain). It will compr

Actual loading method, Actual Loading Method This method is employed c...

Actual Loading Method This method is employed commonly for testing of single phase meters within laboratory. On a meter testing bench that is equipped along with several taps

Explain the procedure of binary to hex conversion, Q. Explain the procedure...

Q. Explain the procedure of Binary to Hex Conversion? It is simple to convert from an integer binary number to hex. This is completed by: Break the binary number int

Define characteristics of discrete time systems - linear, Define Characteri...

Define Characteristics of Discrete Time Systems - Linear? A discrete-time system is said to be linear if it obeys the principles of superposition. That is, the response of a li

Determine the stresses set up in the cylinder and steel wire, A copper cyli...

A copper cylinder 40 cm diameter and 10 mm thick is nearly wound with a layer of 4mm diameter steel wire under a tensile stress of 80 Mpa. If the steam under a pressure of 5 Mpa is

Find a local s-matrix for each triangle, Figure shows two first-order trian...

Figure shows two first-order triangular finite elements used to solve the Laplace equation for electrostatic potential.  Find a local S-matrix for each triangle, and a global S-mat

List out the reasons for automation, Describe the term (i) Automation ...

Describe the term (i) Automation (ii) Automated lines 04 List out the reasons for automation and discuss in detail the process of work part transport.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd