Mov - move instruction, Electrical Engineering

Assignment Help:

MOV ( Move ) Instruction

It copies  the contents of the sources register into destination register. The general format is .

This  instruction  is used  to copy 8 bit  from source  to destination.  There are three  different format for MOV instruction to move data from  register to register , register to memory  and memory  to register as discussed below.

 


Related Discussions:- Mov - move instruction

Magnet, Magnetic materials

Magnetic materials

Electromechanical energy conversion and device, importance of electromechan...

importance of electromechanical energy conversion and device in electrical engineering

Define sampling frequency, Define Sampling Frequency? Since real analog...

Define Sampling Frequency? Since real analog signals consist of several frequencies, spectrum of the input signals should be limited to make sure that no signal energy exists a

What are the display devices, Q. What are the Display Devices? Display ...

Q. What are the Display Devices? Display devices can be categorized as on/off indicators, numeric, alphanumeric, or graphical displays. They may also be classified as active an

Show limitations of microprocessor-based control systems, Q. Show limitatio...

Q. Show limitations of microprocessor-based control systems? Practical limitations of microprocessor-based control systems stem from the following considerations: • Finite-w

Microprocessor, distingish between maximum and minimum modes of operations ...

distingish between maximum and minimum modes of operations of 8086 with timing diagrames

Transistor, what part the transistor plays in the circuit

what part the transistor plays in the circuit

Give the principle of biasing a fet amplifier, Q. Give the principle of bia...

Q. Give the principle of biasing a FET amplifier. To correctly bias the FET, the gate needs to be negative with respect to the source. Bias is obtained in the following manner:

3-phase 180 degree mode vsi , 3-phase 180 0 mode VSI In 1800 mode VSI...

3-phase 180 0 mode VSI In 1800 mode VSI  each thyristor  conduct  for 1800 and two  thyristor  are fired  at 600 interval. For  example  if thyristor  T1  is fired at 00 then

Digital system, 1- Use 4-to-16 decoder and some residue gates to recognize ...

1- Use 4-to-16 decoder and some residue gates to recognize the following functions F1(A,B,C)= S(1,2,4,5,7) F2(A,B,C,D)= S(1,2,4,5,7,10,12,14,15) F3(A,B,C,D,E)= S(1,2,4,5,7,10,12,1

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd