mobile and wirelss communicatio, Electrical Engineering

Assignment Help:

In a CDMA system, the signal is spread over a large bandwidth by multiplying the transmitted symbol by a sequence of short pulses, also called chips. The system bandwidth is thus determined by the duration of a chip. If the chip duration is 0.26 µs and the maximum excess delay is 1.3 µs, into how many delay bins do the multipath components fall? If the maximum excess delay is 100 ns, is the CDMA systems wideband or narrowband?

Related Discussions:- mobile and wirelss communicatio

PSpice Project, I would send the project file so you can take a look at it....

I would send the project file so you can take a look at it.

Complete instruction set of 8085 microprocessor , Complete Instruction Set ...

Complete Instruction Set of 8085 Microprocessor There are total 256 instructions in 8085 microprocessor. These instructions are classified into seven categories according

Three-phase induction motor, Q. A 60-Hz, six-pole, wye-connected, three-pha...

Q. A 60-Hz, six-pole, wye-connected, three-phase induction motor, with the parameters R 1 = R 2 = 0.025 and Xl 1 = Xl 2 = 0.125 , is controlled by variable-frequency control

Illustrate core losses in magnetic core material, Q. Illustrate Core Losses...

Q. Illustrate Core Losses in magnetic core material? Iron-core losses are usually divided into two components: hysteresis loss and eddy-current loss. The former is proportional

Explain the drain characteristics of jfet with external bias, Q. Explain th...

Q. Explain the drain characteristics of JFET with external bias? It gives relation between Id and Vds for different values of Vgs.(which is called the running variable). The ab

Show basic construction of mosfet, Q. Show Basic Construction of MOSFET? ...

Q. Show Basic Construction of MOSFET? The basic construction of the n-channel depletion-type MOSFET is provided in Figure. A slab of p-type material is formed from a silicon

What is the voltage controlled resistance region, Q. What is the Voltage co...

Q. What is the Voltage controlled resistance region? In this region the JFET can actually be employed as a variable resistor whose resistance is controlled by the applied gate

Advantages and disadvantages of direct coupled coupling, Q. Mention the adv...

Q. Mention the advantages and disadvantages of direct coupled coupling? Advantages: 1.Simple circuit due to minimum use of resistor 2.Low

The quantity of electricity transferred., If a current of 10A flows for fou...

If a current of 10A flows for four minutes, find the quantity of electricity transferred. Quantity of electricity, Q=It coulombs. I =10A and t = 4 × 60 = 240s. Hence Q =

Simulation of a pn junction, Simulation of a pn Junction An n + p jun...

Simulation of a pn Junction An n + p junction is fabricated on a p-type silicon substrate with N A = 8×10 15 cm -3 . The n+ region has a concentration of N D = 1.5×10 18

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages