List out the five categories of the 8085 instructions, Electrical Engineering

Assignment Help:

List out the five categories of the 8085 instructions. Give examples of the instructions for each group.

1. Data transfer group - MOV, MVI, LXI.

2. Arithmetic group - ADD, SUB, INR.

3. Logical group -ANA, XRA, CMP.

4. Branch group - JMP, JNZ, CALL.

5. Stack I/O and Machine control group - PUSH, POP, IN, HLT.

Related Discussions:- List out the five categories of the 8085 instructions

What is signal multiplexing, Q. What is Signal Multiplexing? Frequency-...

Q. What is Signal Multiplexing? Frequency-division multiplexing (FDM) and time-division multiplexing (TDM) systems. When data from many sources in time are interlaced, the inte

Input output operations , Input Output Operations Many times microproc...

Input Output Operations Many times microprocessor has to accept data from input port and send data to output port to interact with the real world. Input port is tri st

Electronic Devices, To demonstrate a practical method of testing semiconduc...

To demonstrate a practical method of testing semiconductor diodes.

Equivalent series impedance referred to the high-voltage, Q. A 25-kVA, 2300...

Q. A 25-kVA, 2300:230-V, 60-Hz, single-phase transformer has the following parameters: resistance of high-voltage winding 1.5 , resistance of low-voltage winding 0.015 , leakage

Determine the armature current, A 2300-V, three-phase, wye-connected, round...

A 2300-V, three-phase, wye-connected, round rotor synchronousmotor has a synchronous reactance of 3 per phase and an armature resistance of 0.25 per phase. The motor operates on

Explain block diagram of the system, Q. Explain Block diagram of the system...

Q. Explain Block diagram of the system? The block diagram is a pictorial representation of the equations of the system. Each block represents a mathematical operation, and the

Electric helicopter, examples in building electric helicopter using cardboa...

examples in building electric helicopter using cardboard, balsa wood, scotch tape, glue, binder clips, rubber bands, rubber stoppers, etc. attached to a 12v power supply

Explain jmp instruction and call instruction., Explain the difference betwe...

Explain the difference between a JMP instruction and CALL instruction. A JMP instruction permanently alters the program counter. A CALL instruction leaves information on the st

What is electric field strength, Electric field strength: When two meta...

Electric field strength: When two metal plates are charged and divided in a certain distance, a potential difference will exists among the plates. A force was also generated

Transformer box, a) Illustrate the Schematic diagram of the Transformer Box...

a) Illustrate the Schematic diagram of the Transformer Box used in the Practical Session b) Calculate the output voltage on an Oscilloscope and determine its amplitude and freq

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages