Method of construction - plant layout, Mechanical Engineering

Assignment Help:

Q. Method of construction - Plant layout?

Plant layout is influenced by the intended method of construction, whether the plant is being constructed on-site, or whether modules will be fabricated elsewhere and then assembled on-site. Modular design is popular when considering remote sites, severe weather and the availability of a skilled labor force. Project schedules can be shorter because site civil works can proceed in parallel with module fabrication, and site assembly can be done in more favorable weather conditions.

Modular construction requires a separate design approach; it's not effective to design by conventional methods and then divide it into modules. When locating package units, position a corner that should be considered a fixed point; this allows the unit to grow "away from" if the size should increase. Always check personnel and vehicular access to motors, bundle removal, instrumentation and other features within the package are consistent with the recommendations within this document.


Related Discussions:- Method of construction - plant layout

Design bulk materials storage, Q. Design Bulk Materials Storage? Consid...

Q. Design Bulk Materials Storage? Consideration shall be given to providing access to safety showers in areas of hazardous bulk material handling and storage. Where bulk handli

Motion of this particle, Motion of this particle: A particle of mass m...

Motion of this particle: A particle of mass m is resting on a smooth horizontal plane as illustrated in Figure (a). It is associated to a spring which has a constant of k in f

Explain classification of welding processes, Classification Of Welding Proc...

Classification Of Welding Processes The classificated depending upon the nature of heat source and its movement resulting in spot, seam or zonal welds; or on the extent of heat

Voltage -fundamentals of electricity , Voltage: The voltage is the potent...

Voltage: The voltage is the potential difference between two points. The current flows from higher potential to lower potential. Voltage is measured in volts (V). V = IR

Steps involved for method of section, Step s Involved for Method of Sectio...

Step s Involved for Method of Section: The different steps involved are stated below: (1) First find out support reaction by using equilibrium conditions. (2) The truss

Physical properties of materials, why is physical properties of materials i...

why is physical properties of materials important in design and for industrial application?

Find out the intensity of the external pressure, Find out the intensity of ...

Find out the intensity of the external pressure: A thick cylinder of 0.5 m external diameter & 0.4 m internal diameter is subjected simultaneously to internal & external press

Orthogonal cutting test, In an orthogonal cutting test with a tool of rake ...

In an orthogonal cutting test with a tool of rake angle 10 degree , the following observations were made. 20 Chip thickness ratio = 0.3 Width of cut = 6mm Uncut chip thicknes

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd