Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. Produce the SW parts for the lugs, connector and tubes. Produce an assembly to FIT at the designated points.
2. Create your own, individual, blank, customised drawing template based on the ANSI template in SW and Appendix 1 from Boundy, as a guide. Where Boundy has the Company name, put your Name & Student ID number. Make it your own individual drawing template - it doesn't need a drawing number. Note that you NEED a Title & Drawing Number for each part & assembly drawing.
3. Produce separate part drawings for each tube, the connector and the two lugs as indicated in the hand-drawn sketch [overleaf], a dimensioned assembly drawing with a Bill of Materials [BoM] plus a blank, individual, template drawing sheet from each team member. Teams divide the work so every team member produces a minimum of two (2) drawings plus their individual blank drawing template. Each drawing needs a descriptive title [e.g. NOT LUG 1 or LUG 2] and a sensible drawing number [e.g. MG 001]. Also see Appendix 1 for the connections between item drawings and the assembly drawing through drawing numbers. The assembly drawing must have a Bill of Materials.
Illustrate about the strap footing? In given demonstrates figure the exterior footing placed eccentrically under the exterior column so that property line limitations are not v
A semi-elliptical laminated vehicle spring to took a load of 6000 N is to consist of seven leaves 65 mm wide, two of the leaves extending the full length of the spring. The spring
Five jobs are performed first-on Machine-I and then on Machine-II. Time in hours taken by each job on each machine is given below :
2*2
Internal Energy (U): It is the energy possessed by the system on account of its configurations, and motion of atoms and molecules. Not like potential energy and kinetic energy
A pump station has been designed to lift water out of a 6 metre deep pit (vented to atmosphere) via a centrifigual pump mounted at ground level. Liquid condit
If High Resistance or Low Current in Primary Coil Circuit Causes of Problem Remedy Disconnected or loose wires
Q. Flange Facing and Surface Finish? Raised face flange facings are preferred. Flat face flanges to be used only when mating with like equipment (fabricated from brittle mat
Q. What is IFC in project management? This revision is to be used as a basis for preparing detailed design for final checking of IFC drawings by other disciplines, for incorpo
Choose a wire rope for a vertical mine hoist to lift a load of 55 kN from a depth of 300 metres. A rope speed of 500 metres/min is to be attained in 10 seconds.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd