Joint preparation and identification, Mechanical Engineering

Assignment Help:

The joint bevels shall be prepared in accordance with the registered and approved weld procedure. Internal and external surfaces to be welded shall be clean and free from paint, oil, rust and scale.

Stamp the welder's identification symbol adjacent to all pressure welds with low stress stamp in carbon and low alloy steels with wall thickness of 6.4 mm (1/4") or greater. For flanged joints where the pipe wall thickness is less than 6.4 mm (1/4"), stamp the welders identification on the edge of the flange. When both members of a weld are less than 6.4 mm (1/4") thick, the welder's identity shall be recorded in a permanent written record.

For austenitic stainless steels, high alloy steels and non-ferrous metals, the welder's symbol shall be applied with waterproof paint.

The permanent marking material used on austenitic stainless steels and non-ferrous alloys shall not contain any harmful metal, metal salts, or elements such as zinc, lead, chlorides, sulphur, and other low melting point metals. Submit type of paint or ink including analysis of the above elements for OWNER's approval.


Related Discussions:- Joint preparation and identification

Describe fire clay and kaolinite binders, Q. Describe Fire clay and Kaolini...

Q. Describe Fire clay and Kaolinite Binders? Fire clay : Fire clay is refractory clay usually found in the coal measures. Kaolinite: Its general composition is al 2 o 3

Left side view of a motorcycle parts of motorcycle, Figure : Left Side View...

Figure : Left Side View of a Motorcycle Part No. Name Functions 1 Fuel cock Used to open or close the

Contrary to the misconception, Contrary to the misconception that the grow...

Contrary to the misconception that the growth in automobile industry has catered only to the higher income-stratum of society by producing mostly passenger cars, the fastest growt

Lead acid battery -electrical system , Lead Acid Battery :  The lead acid ...

Lead Acid Battery :  The lead acid type of battery is generally used in all types of two wheelers. It consists of six cells and the rating of the battery is 12 V-2.5 Ah and 12 V-5

Illustrate various kinds of control systems, Illustrate various kinds of co...

Illustrate various kinds of control systems. Illustrate several block diagram reduction rules with examples. Determine C/R by using block diagram reduction method.

Cam-basic components of engine , Cam: This is an integral part of camshaf...

Cam: This is an integral part of camshaft. A cam is designed in such a way as to open or close the valves at the correct timing and keep them open for the necessary duration.

Heat treating equipment, Heat Treating Equipment: The major equipment...

Heat Treating Equipment: The major equipment for heat treatment is furnace. There are two main categories of furnaces - batch and continuous. The furnace selection needs cons

Fracture mechanics, difference between stress intensity factor and stress c...

difference between stress intensity factor and stress concentration factor

Overall deformation of a component, Q. Overall deformation of a component? ...

Q. Overall deformation of a component? The overall deformation of a component is a function of the applied load, the materials' creep rate, the maximum in-service temperature,

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd