Objectives-plastics-reinforced plastics and adhesives, Mechanical Engineering

Assignment Help:

Objectives

After studying this section, you should be capable to:

  • define basic nature of plastics,
  • differentiate between various types of plastics,
  • define polymerisation and its types,
  • understand the term elastometer in a convenient manner,
  • know the properties of plastic, its benefits and drawbacks,
  • define about the engineering plastics and their applications also,
  • define the term reinforced plastic,
  • list the various types of processes to make reinforced plastics,
  • know adhesives,
  • know types of adhesive and their applications also
  • comprise a brief of different design considerations concerning to the plastic.

 


Related Discussions:- Objectives-plastics-reinforced plastics and adhesives

Inlet and exhaust valves-basic components of engine , Inlet and Exhaust Val...

Inlet and Exhaust Valves : Valves are commonly mushroom shaped poppet type. They are provided on the cylinder for regulation of the charge coming into the cylinder (inlet valve)

Determine the acceleration of each block, Determine the acceleration of eac...

Determine the acceleration of each block: In the system of associated blocks shown in figure the coefficient of kinetic friction under blocks A and C is 0.20. Determine the ac

Laminar flow, Consider fully developed laminar flow with constant propertie...

Consider fully developed laminar flow with constant properties in a circular tube. Let there be heat transfered  to or from  the fluid at a constant rate per unit of tube length.Ad

Find out dimension of the cross section of the beam, Q.  A wooden beam of t...

Q.  A wooden beam of the rectangular cross section is subjected to bending moment of 5KNm. If the depth of section is to be double the breadth and stress in wood is not to exceed 6

What are the basic use of sand rammer, Q. What are the basic use of Sand ra...

Q. What are the basic use of Sand rammer? It is the apparatus of make specimens of moulding sand, for tests such as - permeable test, the various strength tests, and shatter te

Cast al alloys, Cast Al Alloys Low melting temperature, good surface f...

Cast Al Alloys Low melting temperature, good surface finish and insolubility to gases except H 2 are characteristics of these alloys. Significant drawback of cast aluminium a

Compute depth of yielding in the hollow shaft, Compute depth of yielding in...

Compute depth of yielding in the hollow shaft: A solid shaft 80 mm diameter is solid for a certain length from one end but hollow for the remaining length along inner diameter

Shear force and bending moment, question no 2,page no 84 of strenght of mat...

question no 2,page no 84 of strenght of materials by G H Ryder

Defects involving inadequate bonding, Defects Involving Inadequate Bonding ...

Defects Involving Inadequate Bonding Lack of fusion Involves lack of complete melting and fusion of some portion of the weld metal in a joint. It may occur either bet

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd