internal combustion engines, Mechanical Engineering

Assignment Help:
During a test on a Lister engine in a thermal laboratory, following parameters were measured;
crank shaft speed=1,750rpm
Load on dynamometer=220N
Radius of dynamometer=1.5m
Fuel consumption= 18.7kg/h
calorific value=43,300kj/kg
mechanical efficiency=83%
determine the brake power?

Related Discussions:- internal combustion engines

Epicyclic Gear Box or Wilson Gear Box, an arrangement of the wilson epicycl...

an arrangement of the wilson epicyclic gearbox giving four forward and one reverse speed of shaft D for an input speed of shaft E is shown in fig .3.in 1st gear Ii is fixed.in 2 ge

Flash butt welding-flashing, Flash Butt Welding-Flashing The phenomenon...

Flash Butt Welding-Flashing The phenomenon of flashing is of extreme importance in achieving satisfactory welds. Flashing can begin only after a molten bridge has been formed s

Flow work - thermodynamics , Flow work: Flow work is energy possessed ...

Flow work: Flow work is energy possessed by the fluid by virtue of its pressure. Displacement Work: When piston moves in cylinder from position 1 to 2 with vo

Evaluate the work done by the gas during the expansion, (a) What do you und...

(a) What do you understand by the following : (i) Open System (ii) Closed System (iii) Concept of ‘Work' (b) 0.014 m 3 gas at a pressure of 2070 KPa expends to a pressure of

Design for dynamic and wear loads, A gear drive is needed to transmit a max...

A gear drive is needed to transmit a maximum power of 22.5KW. The velocity ratio is 1:2 and r.p.m. of the pinion is 200. The centre distance between the shafts can be taken as 600m

Explain classification of welding processes, Classification Of Welding Proc...

Classification Of Welding Processes The classificated depending upon the nature of heat source and its movement resulting in spot, seam or zonal welds; or on the extent of heat

Operations management, case study for factors affecting process design deci...

case study for factors affecting process design decisions

Direct and bending stress, a masonry pier 3m*4m supports vertical load of 6...

a masonry pier 3m*4m supports vertical load of 600kn at point (1.2,1),find stresses at corner of pier

Design lay-down areas for plant, Q. Design lay-down areas for plant? De...

Q. Design lay-down areas for plant? Designated lay-down areas are areas specifically positioned to enable equipment maintenance to be carried out. These are normally assigned f

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd