How to reduce cost in embedded systems, Electrical Engineering

Assignment Help:

Question:

a) Give three ways how to reduce cost in embedded systems.

b) What is a microcontroller? How is it different to a microprocessor?

c) Briefly comment on the "A" register and the "B" register of the 8051 microcontroller.

d) Explain when the "Timer Flag Interrupt" is called and what is the "Reset Interrupt".


Related Discussions:- How to reduce cost in embedded systems

Block diagram of proportional and integral controller, Q. Show Block diagra...

Q. Show Block diagram of proportional and integral controller? The block diagram of Figure illustrates a typical microprocessor system used to implement the digital PI controll

Explain polyphase induction motor, Q. Explain polyphase induction motor? ...

Q. Explain polyphase induction motor? The polyphase induction motor operates with polyphase alternating current applied to the primary winding, usually located on the stator of

Literature review - software defined radio, Literature Review - Software De...

Literature Review - Software Defined Radio In this section, first two methods to estimate signal to noise ratio (SNR) are reviewed and a few methods for modulation classificati

Steps to develop microprocessor based computer system, Explain in brief ste...

Explain in brief steps to develop a Microprocessor based computer system. The design of a microcomputer system should begin with the CPU module. It modules establishes the fund

Describe the phasor equations, Q. Describe the following phasor equations r...

Q. Describe the following phasor equations represented in the time domain: (a) ¯ E = K1e-¯ γz (b) ¯ E = K2e ¯ γz where z is the space coordinate, K1 and K2 are constants,

What is trans conductance, Q. What is Trans conductance? It is ratio of...

Q. What is Trans conductance? It is ratio of small change in drain current to the corresponding change in the gate-to-source voltage for a constant gate-to-source voltage .it i

Bus organisation, Bus Organisation Set of  communication lines in micro...

Bus Organisation Set of  communication lines in microprocessor  which  carry  bits from microprocessor to  peripherals  ( memory  inputs ports  output  ports  and other chips

Calculate the e.m.f. generated in armature of a d.c. machine, The armature ...

The armature of a d.c. machine has a resistance of 0.3 and is connected to a 200V supply. Calculate the e.m.f. generated when it is running (a) as a generator giving 80A (b) as a

Calculate the minimum sampling frequency, Three sine waves along with frequ...

Three sine waves along with frequencies 100Hz, 200Hz and 350Hz and with amplitudes of 1V, 2V and 1.5V correspondingly, are added together to make a single waveform. What is the min

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd