Give the properties of pvc, Electrical Engineering

Assignment Help:

Give the properties of PVC.

PVC- It is acquired from polymerisation of hydrogen chloride and acetylene in the presence of a catalyst as peroxides at about 500C.

Properties:

1. PVC is a white powder.

2. Its resin is hard, very little flexible and insoluble in many solvents.

3. Properties as porosity, mechanical strength and flexibility, electrical properties and moisture absorption can be changed by adding materials or fillers.

4. It has good mechanical and electrical properties.

5. PVC resists flame, sunlight and most solvents.

6. PVC is non-hygroscopic.


Related Discussions:- Give the properties of pvc

Latch - introductio to microprocessors , Latch A 8 bit  latch comprise...

Latch A 8 bit  latch comprises of transparent latch D flip  flop. It is commonly  used  to interface output  device with  microprocessor. A typical example of such 8 bit  latc

Find the rotor copper loss, A three-phase, 50-hp, 440-V, 60-Hz, four-pole, ...

A three-phase, 50-hp, 440-V, 60-Hz, four-pole, wound-rotor inductionmotor operates at a slip of 0.03 at full load,with its slip rings short-circuited. The motor is capable of devel

Explain the properties and application of glass, Explain the properties and...

Explain the properties and application of glass. Glass: Ordinary glass is a fine insulator but is too brittle to be used for anything although scientific instrument parts, accu

Construction and operation of enhancement mosfet, Q. Explain the constructi...

Q. Explain the construction and operation of Enhancement MOSFET? The construction of an N-channel enhancement MOSFET is shown in figure below. Two highly doped N + regions are

Explain position servo in a radar system, Q. Explain Position servo in a ra...

Q. Explain Position servo in a radar system? Figure depicts the essential elements of a position servo system. In a radar system, an electromagnetic pulse is radiated from an a

Determine the efficiency, Q. (a) Consider a three-phase star or wye half-wa...

Q. (a) Consider a three-phase star or wye half-wave recti?er with a purely resistive load R. Determine: (i) efficiency, (ii) formfactor, (iii) ripple factor, (iv) TUF, and (v) PIV

Determine the fraction of full load, The distribution transformer is supply...

The distribution transformer is supplying a load at 240 V and 0.8 power factor lagging. The open-circuit and short-circuit test data are given in Example. (a) Determine the frac

Construct a truth table and get the minimum sop expression, Q. For the logi...

Q. For the logic circuit of Figure, construct a truth table and obtain the minimum SOP expression.

Determine the open-circuit output voltage, Q. Determine the open-circuit ou...

Q. Determine the open-circuit output voltage v o of the system shown in Figure as a function of the input voltage v i .

Find the flux density in the air gap of the right leg, Q. In the magnetic c...

Q. In the magnetic circuit shown in Figure the center leg has the same cross-sectional area as each of the outer legs. The coil has 400 turns. The permeability of iron may be a

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd