Fulfilled to sustain the oscillations, Electrical Engineering

Assignment Help:

Q. What are the conditions required to be fulfilled to sustain the oscillations?

The conditions required to be fulfilled to sustain the oscillations are:

1. The loop gain must be greater than unity at oscillator frequency.

2. After the desired output level is reached, Ab must decrease to 1.

3. At oscillator frequency, net phase shift around the loop must be zero or integer multiple of 360 degrees so that the feedback signal is in phase with the starting infinitesimal voltage.

4. The amount of energy fed back to input must be sufficient to overcome the energy losses in the input circuit.


Related Discussions:- Fulfilled to sustain the oscillations

#t voice controlled mobile base, The aim of this project is to design, co...

The aim of this project is to design, construct and build a motorised base driven by two small dc motors. The motor drives are two H-bridges. The switching devices in these bridges

Explain working of phase shift oscillator, Explain working of Phase Shift O...

Explain working of Phase Shift Oscillator? Figure shows a phase shift oscillator. Here the combination of ReCe provides self bias for the amplifier. The phase of the signa

#titleclipper diode.., Ask quedisadvantages stion #Minimum 100 words accept...

Ask quedisadvantages stion #Minimum 100 words accepted#

What is the use of ale, What is the use of ALE The ALE is used to latch...

What is the use of ALE The ALE is used to latch the lower order address so that it can be available in T2 and T3 and used for identify the memory address. During T1 the ALE goe

Write a control word for counter 1 of 8253 / 8254, Write a control word for...

Write a control word for counter 1 of 8253 / 8254 that selects the following options:  load least significant byte only, mode 5 of operation and binary counting.  Then write an ins

Sketch the phasor diagram, Q. A balanced delta-connected load with a per-ph...

Q. A balanced delta-connected load with a per-phase impedance of 12 + j9  is supplied by a 173-V, 60-Hz three-phase source. (a) Determine the line current, the power factor, th

Determine ripple factor of half wave rectifier, Illustrate VI Characteristi...

Illustrate VI Characteristics of PN junction diode (10) Illustrate Half Wave Rectifier. Disadvantage of Half Wave Rectifier. Determine ripple factor of Half Wave Rectifier.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd