Explain the test instruction, Electrical Engineering

Assignment Help:

Explain the TEST instruction.

TEST: The TEST instruction executes the AND operation. The difference is as the AND instruction changes the destination operand, whereas the TEST instruction does not. This TEST only affects the condition of the flag register that indicates the result of the test.


Related Discussions:- Explain the test instruction

Permanent magnets are made of which type of material, Permanent magnets are...

Permanent magnets are made of (A)  Soft magnetic materials.            (B) Hard magnetic materials. (C) Semi conductors.                        (D)  Super conductors.

Explain the modes of connection for polyphase transformers, Discuss the mod...

Discuss the modes of connection for polyphase transformers Discuss with aid of electrical grouping and wiring connection diagrams the different types of connections for polypha

Compute the area of each plate, Q For a parallel-plate capacitor with plate...

Q For a parallel-plate capacitor with plates of area A m 2 and separation d m in air, the capacitance in farads may be computed from the approximate relation Compute the a

find the current and voltage by ohms law and kvl, 1. A current carrying co...

1. A current carrying conductor is found to carry 10 μA at a given time slot from 5μs to 1.5 ms. Find the total number of electrons flowing in the conductor during this time slot.

Explain power-system loads, Q. Explain Power-System Loads? Figure repre...

Q. Explain Power-System Loads? Figure represents a one-line (single-line) diagram of a part of a typical three-phase power system. Notice the symbols that are used for generato

Determine whether the diode in circuit, Determine whether the diode (consid...

Determine whether the diode (considered to be ideal) in the circuit of Figure (a) is conducting.

Estimate the network resistance, When three resistors R1, R2 and R3 are con...

When three resistors R1, R2 and R3 are connected in parallel as shown in the diagram. For these resistors the equivalent resistance is given by: a. Derive a rule to

Slip-power controlled wound-rotor induction-motor drives, Q. Slip-power con...

Q. Slip-power controlled wound-rotor induction-motor drives? Slip power is that portion of the air-gap power that is not converted into mechanical power. The methods involving

Student, Can I get some ideas for power system stability simulation using M...

Can I get some ideas for power system stability simulation using Matlab?

The internal resistance of the zener diode, A 9.1V zener diode has a nomina...

A 9.1V zener diode has a nominal voltage fall at a test current of 28mA. The internal resistance of the zener diode is 5 ohms. Find the voltage drop across the zener diode at zener

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd