Friction is undesirable, Mechanical Engineering

Assignment Help:

Friction is Undesirable:

A friction is undesirable at the time of ice skating or when the block is lifted or put down on the truck with the help of inclined plane. If friction is more between block and inclined surface, then large force is required to push block on plane.

Thus friction is desirable or undesirable that depends upon the situation and types of work.

 

 


Related Discussions:- Friction is undesirable

Heat conduction duhamels method, Procedure for solving a problem using duha...

Procedure for solving a problem using duhamels method

Significance of defects in welds, SIGNIFICANCE OF DEFECTS IN WELDS   ...

SIGNIFICANCE OF DEFECTS IN WELDS   In the correct sense of the word, a defect is a rejectable discontinuity or a flaw of rejectable nature. Certain flaws acceptable in one t

Chisel-tool and equipment , Chisel: Chisels are used in the combination of...

Chisel: Chisels are used in the combination of hammer to remove metals. A set of chisels is shown in Figure. Figure: Chisel

What do you mean by bunds and dikes, Q. What do you mean by Bunds and Dikes...

Q. What do you mean by Bunds and Dikes ? A bund (or dike) is an embankment or wall of brick, stone, concrete or other impervious material, which surrounds the entire perimeter

Maximum permissible stress in belt, Maximum permissible stress in belt: ...

Maximum permissible stress in belt: Q: A belt 100mm wide and 8.0mm thick are transmitting power at belt speed of 160m/minute.  The angle of lap for smaller pulley is 165º an

Define 3-d lathe tool dynamometer, Define 3-D lathe Tool Dynamometer It...

Define 3-D lathe Tool Dynamometer It is possible to measure three dimensional cutting tool component with the help of 3-D lathe tool dynamometer. In spite of that we are gone f

Define the project scope, Q. Define the project scope? The Design Basis...

Q. Define the project scope? The Design Basis Memorandum defines the project scope. This includes basic design concepts and the basis and philosophies upon which the project s

Capacity planning, Capacity Planning: This unit defined different ways...

Capacity Planning: This unit defined different ways to measure capacity, set up maximum capacity, and calculate capacity utilization. The long-term and short-term strategies t

Compare rankine cycle with carnot cycle - thermodynamics, Compare Rankine c...

Compare Rankine cycle with Carnot cycle: Sol.: Rankine cycle without superheat: 1 - A - 2 - 3 - 4 - 1. Rankine cycle with superheat : 1 - A - 2 - 2′ -3′ - 4 - 1.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd