Find the total per-phase inductance, Electrical Engineering

Assignment Help:

A 300 km, 3-phase, 50Hz transmission line has spacing as shown in Figure. Each phase of the line consists of a bundle of three conductors.

(a) Find the total per-phase inductance and the total per-phase shunt capacitance of the line if the conductors have diameter of 2.4cm and a GMR of 0.88cm. Assume bundle spacing

d = 0.4m.

(b) Find the % change of the resistance, inductance and the capacitance if the line is modified by adding one more conductor of the same size and type to the bundle.

(c) Use Matlab to check your results in (a) and( b). Comment if the results agree or not.

1532_matlab diagram.png


Related Discussions:- Find the total per-phase inductance

Define salient-pole rotor construction - synchronous machine, Define Salien...

Define Salient-pole Rotor Construction - Synchronous Machines? Salient-pole rotor construction on the other hand, may be used for low to medium speed applications. The machines

Explain the synchronous up-down counters, Explain the Synchronous Up-Down C...

Explain the Synchronous Up-Down Counters? The circuit of a 3-bit synchronous up-down counter and a table of its sequence are shown below.  Alike to an asynchronous up-down count

Active-mode npn transistors in circuits, Active-mode NPN transistors in cir...

Active-mode NPN transistors in circuits Figure:  Structure and use of NPN transistor. Arrow according to schematic. The figure opposite is a schematic presentation

Find the maximum probable percentage error, Q. A current of 65 A is measure...

Q. A current of 65 A is measured with an analog ammeter having a probable error of ±0.5% of full scale of 100 A. Find the maximum probable percentage error in the measurement.

Explain telephone hand set and it’s working, Q. Explain Telephone hand set ...

Q. Explain Telephone hand set and it’s working ? A standard telephone set is comprised of a transmitter, a receiver and electrical network for equalization, associated circ

Which Transistor configuration best to use in cascade, Q. Which of the 3 tr...

Q. Which of the 3 transistor configuration is best to use in cascade if maximum voltage gain is to be realized?  The common collector configuration is not used for intermediate

Find the power supplied by the voltage source, Find the power supplied by t...

Find the power supplied by the voltage source and the power absorbed by the 24 Ω resistor (R3) in the circuit shown below:   Determine the voltage V2 in the circuit shown.

Electronic monitor and alarm system for an oil separator, This assignment i...

This assignment is to develop a User Requirements Specification for an electronic monitor and alarm system for an Oil Separator in Surface Water Drainage Systems. These separato

Amplifier and active filter design, Amplifier and Active Filter Design Usin...

Amplifier and Active Filter Design Using Operational Amplifier 1) The purpose of this assignment is to train you to do some simple circuit design using op-amp. The circuit tha

Sinusoidal, Give the examples of sinusoidal with two equations?

Give the examples of sinusoidal with two equations?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd