Find speed for two hours with hss tools, Mechanical Engineering

Assignment Help:

Find speed for two hours with HSS tools

Find speed for two hours tool life for dry machining of free cutting mild steel with HSS tool.

Solution

From Table 3, a value of C = 74 m/min is chosen while for HSS tool a mean value of n = 0.125 has been assumed.

V tn = C

V = C /t n

=  74 /1200.125

= 74 /1.82

= 40.67

= 40.67 metres/minute

Table 3: Constant C for Taylor's Equation

990_Tool Life Equation 1.png


Related Discussions:- Find speed for two hours with hss tools

Calculate the average heat transfer coefficient, Air at 1 atm, 300K, and Re...

Air at 1 atm, 300K, and Re = 50,000: a. Flow across the cylinder with a diameter of 10 cm. b. Flow inside a tube with a diameter of 10 cm. c. flow along the flat plate of

Excessive pedal pressure required motorcycle problem, If Excessive Pedal Pr...

If Excessive Pedal Pressure Required Causes of Problem Remedy Incorrect shoe placement Improper anchor pin position l

Cam-cam illustrations, Cam This is a mechanical member that imparts mot...

Cam This is a mechanical member that imparts motion to another member called follower. Illustration: A cam is rotating at regular speed of 1200 rpm in the clockwise d

Determine the reactions at supported end, A steel dia 10 mm passes through ...

A steel dia 10 mm passes through a brass tube of internal dia 15mm and external dia is 25 mm. The bolt is tightened by a nut. The length of tube is reduced by 1.5mm and the length

Explain corner joint, Corner joint- The flush corner joint is designed prim...

Corner joint- The flush corner joint is designed primarily for welding sheet metal that is 12 gauge or thinner. It is restricted to lighter materials. The half-open corner join

Design and construction of waste heat boilers, Shop assembled, steam drum, ...

Shop assembled, steam drum, risers, downcomers, and all other related equipment on the steam side shall be designed, fabricated and hydrostatically tested to all requirements of AS

Polymer, classification of polymers

classification of polymers

Pp, matle cutting

matle cutting

Access and maintenance for pumps, Pumps should be grouped together with goo...

Pumps should be grouped together with good maintenance access to the motor, and good personnel access to seals and suction / discharge valves. Maintenance access should allow for r

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd