Find length of belt, Mechanical Engineering

Assignment Help:

Find length of belt:

Find length of belt which is required to drive a pulley of 500mm diameter running parallel at the distance of 12m from driving pulley of diameter 1600m.

Sol: Given Data

Diameter of driven pulley     (D2) = 500mm = 0.5m

Radius of driven pulley     (r2) = 0.25m

Centre distance                    (X) = 12m

Diameter of driver pulley      (D1) = 1600mm = 1.6m

Radius of driver pulley      (r1) =0.8m

As there is no mention about type of belt

So we find out for both the cases. (i) Length of belt if it is open
WE know that  2122_Find length of belt.png 
By putting all the value
2204_Find length of belt1.png 
L = 27.32m

 (ii) Length of belt if it is cross

We know that:

2460_Find length of belt2.png

By putting the value

672_Find length of belt3.png  

 


Related Discussions:- Find length of belt

What is a clay-characteristics , 1.  What is a soil in an engineering conte...

1.  What is a soil in an engineering context? Define. 2.  (a)  What is a clay? (b) What are the major properties and characteristics of clay? Discuss. (c)  Define the term

Determine the maximum stress, The cross-section of two angles attached tog...

The cross-section of two angles attached together are shown on the left below. The properties of angles are given in the table with reference to the diagram on the right. The ma

Explain side cutting edge angle, Explain Side Cutting Edge Angle It is ...

Explain Side Cutting Edge Angle It is angle between the side cutting edge and the longitudinal axis of the tool. It avoids formation of build up edge, controls the direction of

Improvement of existing airport, Improvement Of Existing Airport: The ...

Improvement Of Existing Airport: The improvements that are usually needed for existing airports fall under the following categories : (a)        Extension of runway to acco

The radius dimension command, The Radius Dimension Command The Radius c...

The Radius Dimension Command The Radius command is quite identical to the Diameter command except that the dimension measurements a radius rather than a dimension and the resul

Calculate the axial deflection and angle of rotation, Calculate the axial d...

Calculate the axial deflection and angle of rotation: Any open coiled helical spring along with 10 complete turns is built of 16 mm diameter steel rod, the mean radius of the

Check ferrite content of austenitic stainless steel weld, Q. Check ferrite ...

Q. Check ferrite content of austenitic stainless steel weld? Check the ferrite content of each austenitic stainless steel weld, including overlay welds, in the as-welded condit

Time dilation, Time Dilation The measurement of time involves the conce...

Time Dilation The measurement of time involves the concept of clocks attached at each position co-ordinate of a Lorentz frame. As a consequence of Lorentz transformations, it i

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd