Explain working of plate heat exchangers, Mechanical Engineering

Assignment Help:

Q. Explain working of plate heat exchangers?

For gasket plate heat exchangers handling flammable materials, the same spacing requirements for air coolers should be applied. If handling flammable materials and located within 6 m (20 ft.) horizontally of equipment with a high fire potential, the plate exchanger should be fireproofed. Plate exchangers tend to be small compared to shell & tube exchangers of equivalent duty. Piping and supports shall be arranged to allow plate withdrawal so that maintenance facilities and escape or access routes are not obstructed. Sufficient space is required all around these exchangers for plate removal and cleaning. Plate exchangers normally sit on sloped paved floors for wash down and spillage collection.


Related Discussions:- Explain working of plate heat exchangers

Design air coolers for plant layout, Q. Design Air Coolers for plant layout...

Q. Design Air Coolers for plant layout? As air coolers (sometimes called aerial coolers, or fin-fans) have extensive heat transfer surfaces, they are more vulnerable to failure

Design equipment rooms for plant, Q. Design Equipment Rooms for plant? ...

Q. Design Equipment Rooms for plant? Equipment for important safety systems and controls shall be located such that they can remain operational during the defined accidental ev

Describe span of bridge and varying depth, The press tressed bridge structu...

The press tressed bridge structure would look like as shown below,   The following factors influences the decision to select the particular prestressing, 1/Span of br

Martempering, Martempering: The piece to be hardened is wholly austen...

Martempering: The piece to be hardened is wholly austenitized and after that quenched in a lead of salt bath held at a temperature simply above at that martensite would begin

If o ring found to be leaking-oil seal is found be leak, If "o" ring is fou...

If "o" ring is found to be leaking or oil seal is found to be leaking check as mentioned: If "O" ring found to be leaking change "O" rings. If oil seal found to be leaking check o

Production engineering, what are the finishing operation in construction of...

what are the finishing operation in construction of telephone receivers?

Assignment , assignment on the topics of preservation of safety & accident

assignment on the topics of preservation of safety & accident

Relative motion, the jet transport B is flying at the velocity of 600km/h w...

the jet transport B is flying at the velocity of 600km/h when a smaller aircraft A passes underneath the transport headed in the 60 degree direction. To passengers in B, however ap

Calculate the maximum bending movement, A beam, 6 m long is simply supporte...

A beam, 6 m long is simply supported at the ends, and carries a uniformly distributed load of 15 KN/m and three loads of 10 KN, 20 KN and 30 KN acting respectively at the centre po

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd