Explain the standard for exchange and transfer, Mechanical Engineering

Assignment Help:

Standard for Exchange and Transfer (SET)

The interface SET is a standard for the exchange of all data which is generated for CAD/CAM. It is a French development and was first published in 1984 (SET 85). Several additions have been published since (SET F88, SET S 88 and SET V88). 

The information transferred via the SET interface are wire-frame, surface, B-representation and FEM models, as well as technical drawings and scientific data. Organizational, material property and tolerance information cannot be defined by individual models but they must be contained in the drawing for transfer.

 


Related Discussions:- Explain the standard for exchange and transfer

Describe dry and wet parting materials, Q. Describe Dry and wet parting mat...

Q. Describe Dry and wet parting materials? Dry parting materials: These are applied by dusting. These include : charcoal, ground bone and limestone, lycopodium(a yellow veget

Evaluation of machine design, With the help of diagram , depict the evaluat...

With the help of diagram , depict the evaluation of Machine Design. Discuss in detail Technical feasibility, finanacial and economic feasibility, social and environmental feasib

How do we calculate the productivity, Describe productivity. How do we calc...

Describe productivity. How do we calculate the productivity? Enumerate various factors effecting the productivity. Define various ways for the improvement of productivity.

Determine ratio between mass flow rate to condensing steam, Determine ratio...

Determine ratio between mass flow rate to condensing steam: In steam power plant, the steam 0.1 bar and 0.95 dry enters condenser and leaves as saturated liquid at 0.1 bar an

The same magnitude as it did at the bottom, For the normal force in Figure ...

For the normal force in Figure to have the same magnitude at all points on the vertical track, the stunt driver must adjust the speed to be different at different points. Suppose,

Coated electrodes and their classifications, COATED ELECTRODES AND THEIR CL...

COATED ELECTRODES AND THEIR CLASSIFICATIONS Welding technology has changed tremendously over the past decades. Its application is found in all sectors of industries, smaller or l

Illustrate the babcock and wilcox boiler, How the boiler are classified? Sk...

How the boiler are classified? Sketch and define the babcock & Wilcox boiler and also Compare the water tube boiler and fire tube?

Flange assembly with bolt tensioning, Q. Flange Assembly with Bolt Tensioni...

Q. Flange Assembly with Bolt Tensioning? Measure the free length of the bolts ultrasonically. This must be done prior to applying any load to the bolt. Install bolts on the

Simply supported beam, Simply Supported Beam: Simply Supported Beam: ...

Simply Supported Beam: Simply Supported Beam: The beam on which both ends are supported, either by point load or hinged or roller support.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd