Explain moulding sand for non-ferrous casting, Mechanical Engineering

Assignment Help:

Q. Explain Moulding Sand for Non-ferrous Casting?

The melting point of non- ferrous metal is much lower than that of ferrous metals. Therefore, the moulding sands for non-ferrous casting may be less refractory and permeable. Also, a smooth surface is desirable on non-ferrous casting. Due to all this, the moulding sands for non-ferrous casting contain a considerable amount of clay and fine grained.


Related Discussions:- Explain moulding sand for non-ferrous casting

Mechnics of solids thick cylinder, a compound cylinder is composed of a tub...

a compound cylinder is composed of a tube of 250mm internal diameter at 25mm wall thickness.it is shrunk on to a tube of 200mm internal diameter. the radial pressure at the junctio

Steam generator load balancing, Q. Steam Generator Load Balancing? The ...

Q. Steam Generator Load Balancing? The pressure controller output is cascaded to individual stations, one for each boiler. These allow selective increase or decrease of the du

Flange assembly with bolt elongation measurement, Q. Flange Assembly with B...

Q. Flange Assembly with Bolt Elongation Measurement? Bolt elongation measurement may be used, with COLT engineering approval, at flanges where Hydraulic Bolt Tensioners are imp

Method of construction - plant layout, Q. Method of construction - Plant la...

Q. Method of construction - Plant layout? Plant layout is influenced by the intended method of construction, whether the plant is being constructed on-site, or whether modules

Blasting abrasive, Blasting Abrasive: Sand had been use widely before ...

Blasting Abrasive: Sand had been use widely before new abrasive media invented. Today, manufacturer had more choices and better options in choosing blasting media for their ow

Discover the angle of twist - uniformly varying shaft, Discover the angle o...

Discover the angle of twist - uniformly varying shaft: A uniformly varying shaft of length 2 m is subjected to a torque of 2 kN-m. The diameter at the ends shall be 60 mm and

., what is fluid?

what is fluid?

Estimate the horizontal at equilibrium angel, (Rigid body acceleration) A ...

(Rigid body acceleration) A tank of water accelerates down an icy frictionless ramp of angle . What angle ( ) does the water make with the horizontal at equilibrium?

Tensile strength, Tensile strength: What will be its ultimate tensile ...

Tensile strength: What will be its ultimate tensile strength? Solution The condition for necking is = n = 0.3077 Hence using this value of , the true stress at ne

How do we adjust throttle free play?, (a) What is the function of a throttl...

(a) What is the function of a throttle valve? Where it is used? (b) How do we adjust throttle free play?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd