Explain fluidized-bed incinerators, Civil Engineering

Assignment Help:

Explain Fluidized-Bed Incinerators

sand is heated to 800C by oil or gas and blown around (fluidized) by a blower that sends air from bottom upward
heated fluidized sand hits sludge, breaks it apart, and burns it
glass and metals must be removed from refuse to incinerated
able to burn wastes of widely variable moisture and heat content (i.e. paper and wood)

Related Discussions:- Explain fluidized-bed incinerators

Designing of access ramps for drainage channels, Question Designing of ...

Question Designing of access ramps for drainage channels, why must direction of access ramps is sloping down on the way to downstream ? Answer In designing of access

Highway pavement design, Explain the important factors affecting the design...

Explain the important factors affecting the design of pavement?

Mechanics of structure, distinush between determinant and indeterminant pla...

distinush between determinant and indeterminant plane trusses

MASONRY WORK, JOINTS IN MASONRY WORK

JOINTS IN MASONRY WORK

Determine the flow area of storm water, Storm water flows at a depth of 4 f...

Storm water flows at a depth of 4 ft in the natural channel as shown in the figure. The channel has a slope of 0.0l ft/ft and n = 0.025. 1. Determine the flow area:

Explain the term - uniaxial - biaxial -triaxial prestressing, Explain the t...

Explain the term - Uniaxial - Biaxial -Triaxial Prestressing These terms refer to cases when the concrete is prestressed in only one direction, in two mutually perpendicular di

Ductility test, Ductility Test: The ductility of a bituminous binder ...

Ductility Test: The ductility of a bituminous binder is its ability to deform under load and return to its original condition after removal of the load. The property is deter

State the location and spacing of borings, Location and spacing of borings ...

Location and spacing of borings The location, spacing of geophysical profiles, soundings and borings should be such that, you will be in a position to accurately predict the

Surveying, length of the line measured with 20m chain found to be 250m.calc...

length of the line measured with 20m chain found to be 250m.calculate true length if the chain was 10cm long

Bricks, BRICKS Brick is obtained by moulding good clay into a block, wh...

BRICKS Brick is obtained by moulding good clay into a block, which is dried and then burnt. It is the oldest building block to replace stone. Manufacture of brick started havin

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages