Explain direct data addressing mode, Electrical Engineering

Assignment Help:

Direct data addressing mode (with examples) available in microprocessors.

Direct Mode:

  • Instruction comprises memory access.
  • CPU accesses which location into memory.

Illustration:

LDAC 5

Reads this data from memory location 5, and stores this data in the CPU's accumulator.


Related Discussions:- Explain direct data addressing mode

Fast recovery diodes - types of power diodes , Fast  Recovery diodes ...

Fast  Recovery diodes The fast  recovery  diodes low recovery times. These diodes  are manufactured by diffusion. They are used in converter circuits where  the speed  of reco

Khalid, i need to rewrite 24 pages of engineering research.

i need to rewrite 24 pages of engineering research.

Compute the speed of the rotor, A 3 phase 60 hertz induction motor has 8 po...

A 3 phase 60 hertz induction motor has 8 poles and operates with a slip of .05 for a certain load. Compute in r.p.m. the (a) Speed of the rotor with respect to the stator, (b

Determine the self inductance of the two coils, Determine the self inductan...

Determine the self inductance of the two coils: Two coils with a coefficient of coupling of 0.6 between them are connected in series so as to magnetize (i) in the same directi

Explain steady-state stability, Q. Explain Steady-State Stability? The ...

Q. Explain Steady-State Stability? The property of a power system that ensures that it will remain in equilibrium under both normal and abnormal conditions is known as power-sy

Static rotor resistance control methods - motor control , Static Rotor Res...

Static Rotor Resistance Control Methods This method is used only for slip  ring induction motor in SRIM  3- phase  variable  resistor can be inserted in the rotor  circuit and

.harmonics, describe the practical application of series resonance in ac ci...

describe the practical application of series resonance in ac circuits

Plc and control system analysis, The assignment is to plan, design and writ...

The assignment is to plan, design and write a PLC program on the FX Training Software using a PART SUPPLY CONTROL SYSTEM based on the requirement specification outlined be

Ohm, what is ohm?

what is ohm?

Determine the range of the step size, 1. (a) Consider a sinusoidal signal m...

1. (a) Consider a sinusoidal signal m(t) = A cos(2 Π f m t) applied to a delta modulator with step size . Determine the range of the step size so that slope overload will be avoide

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd