Application of plc - stepper motor , Electrical Engineering

Assignment Help:

Application of PLC

a. A PLC  is used to start  and stop  the motors  of a segmented conveyor beli. This  allows  only belt section carrying  a copper plate to move.

b.In automated system PLC  controller is usually the central part of a process control  systems.

c.To run  more  complex  process  it is possible  to connect more PLC  controllers  to a central  computer.


Related Discussions:- Application of plc - stepper motor

Introduction to electronics, Explain the difference between a microprocesso...

Explain the difference between a microprocessor and an embedded microcontroller

Explain about subscriber loop system, Q. Explain about Subscriber Loop Syst...

Q. Explain about Subscriber Loop System? Subscriber Loop System:Each subscriber in a telephone network is connected normally to the nearest switching office by a dedicated pair

determine the minimum dandwidth of the system - fsk and ask, 1. Data is to...

1. Data is to be transmitted using a modem at 9600 bps. Determine the minimum bandwidth of the system with the following modulation methods (a) FSK (b) ASK. Use the excess

Show demagnetizing effect of armature reaction, Q. A20-hp, 250-Vshuntmotor ...

Q. A20-hp, 250-Vshuntmotor has a total armature - circuit resistance of 0.25  and a field-circuit resistance of 200.At no load and rated voltage, the speed is 1200 r/min, and the

Applied electronics, What is coupling? Explain the types of coupling

What is coupling? Explain the types of coupling

Determine the armature current and power factor of the motor, A three-phase...

A three-phase, wye-connected, 2300-V, 60-Hz, round-rotor synchronous motor has a syn- chronous reactance of 2 per phase and negligible armature resistance. (a) If the motor tak

Radio over Fiber, I need to get a summary for a radio over fiber paper that...

I need to get a summary for a radio over fiber paper that I have , the summary need to be on the following format: abstract, introduction,methodology,results, conclusion and refere

Matlab codes for transportation problem, i need matlab codes for the minimu...

i need matlab codes for the minimum cell cost method to start the initial feasible solution and the stepping stone method to find the optimum value

Find load resistance and voltage, Q. Find load resistance and voltage? ...

Q. Find load resistance and voltage? Let the amplifier block be connected to a current source at the input terminals, as shown in Figure(a), and to a load resistance R L at it

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd