Explain conveyor and auger, Mechanical Engineering

Assignment Help:

Conveyor and auger

Two Hydraulic motors are provided for individual control of two conveyors and Auger, which are provided for individual control of material on both the sides of machine

AUGERS

The augers are driven and actuated independently from the conveyors. The Left-hand and the right hand half of the auger can be controlled separately. The drive System is fully hydraulic. The conveying direction can be changed towards the center or towardthe outside. This ensures that there is always a sufficient supply with material even if an excessive amount of material is required at one side. The auger speed is continuously controlled by sensors that monitor the material flow.

 


Related Discussions:- Explain conveyor and auger

Relation for fin insulated tip and the heat dissipation, Derive the relatio...

Derive the relation for a fin insulated at the tip and the heat dissipation?

Determine the angle of twist - solid steel shaft, Determine the angle of tw...

Determine the angle of twist - solid steel shaft: A solid steel shaft 6 m long is fixed at each of the end. A torque of 3 kN-m is applied to the shaft at a section 2 m from on

Project in Automobiles or Robotics, I am studying in Final Year of Engineer...

I am studying in Final Year of Engineering(Mechanical) and I would like some help for the project. It will be helpful if you suggest some project related to Automation.

Illustrate critical damping, Illustrate any three of the following : (i)...

Illustrate any three of the following : (i) Critical Damping (ii) Logarithmic decrement (iii) Vibration Isolation (iv) Equivalent stiffness of spring in series and in p

Find the magnitude and position , Q1. A short vertical column consists of ...

Q1. A short vertical column consists of a channel section with the dimensions shown in Figure 1(a). The column (part of a system used to support a machine) carries a compressive p

Describe and derive an expression for energy method, Split the harmonic mot...

Split the harmonic motion x=10 sin (wt + 30 0 ) into two harmonic motions one having a phase angle of zero and the other of 45 0 . Describe and derive an expression for energy m

Calculated the magnitude of the instantaneous stress, Calculated the magnit...

Calculated the magnitude of the instantaneous stress: While a concentrated force of 1 kN is applied at the midspan point of a simply supported beam a static deflection of 5 mm

Explain about the CAD system, Explain about the CAD system. CAD systems...

Explain about the CAD system. CAD systems generally require considerable processor power and a number of output and input devices; for instance: - Light pens - Large scre

Scope of corrosion assessment design, Q. Scope of corrosion assessment desi...

Q. Scope of corrosion assessment design? The purpose of this guideline is to describe the common corrosion damaging modes and mitigation methods and provides recommended materi

Factors affecting the selection of boiler, F AC T OR S AFFECTING THE SE...

F AC T OR S AFFECTING THE SELECTION OF BOILER: -     Working Pressure and amount of steam needed. -     Floor area required. -     Operating and Maintenance Required

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd