Explain butt joints, Mechanical Engineering

Assignment Help:

Butt joints-formed by placing the plates edge to edge and welding them. Grooves are sometimes cut (For thick plates) on the edges before welding. According to the shape of the grooves, the butt joints may be of different types, e.g.,

 

1890_Explain Butt joints.png

 

Figure-Butt joints

  • Square butt joint
  • Single V-butt joint, double V-butt joint
  • Single U-butt joint, double U-butt joint
  • Single J-butt joint, double J-butt joint
  • Single bevel-butt joint, double bevel butt joint

 


Related Discussions:- Explain butt joints

Dryness fraction measurement - thermodynamics, Dryness fraction measurement...

Dryness fraction measurement: Sensible Hea t of Water or Heat of Liquid or Enthalpy of Liquid (h) Sol.: It is quantity of heat which is required to raise unit mass

Types of stresses, Types of stresses: In general stress is divided in ...

Types of stresses: In general stress is divided in to three group as: various types of stresses may be classified as: 1. Simple or direct stress (Tension, Compressi

Objectives- computer algorithm for on-line scheduling , Objectives After...

Objectives After studying this section, you should be capable to understand: Cell aspects of scheduling, Conventional priority rules, Newer approaches to on line

CO2 welding-equipment, CO 2 WELDING CO 2 welding is one of the variat...

CO 2 WELDING CO 2 welding is one of the variations of t he GMAW (Gas Met al Arc Welding) process which is now used for welding most structural and alloy steels. The operating

Voltage -fundamentals of electricity , Voltage: The voltage is the potent...

Voltage: The voltage is the potential difference between two points. The current flows from higher potential to lower potential. Voltage is measured in volts (V). V = IR

Clutch free play-clutch complaints, Clutch free play : Check for free play ...

Clutch free play : Check for free play of the clutch lever. It should be within 10-20 mm.

Forces working on dam, Forces working on dam: Let a dam retaining wate...

Forces working on dam: Let a dam retaining water as illustrated in Figure (a). What are the forces working on it? Solution The forces working on dam are as follows:

Safety functions - industrial safety, Safety Functions - Industrial Safety ...

Safety Functions - Industrial Safety In the statement about safety organization various functions have been mentioned. Yet, a clear description is lacking. Without much elabor

Reciprocating compressor, Derive the relation ship between volumetric effic...

Derive the relation ship between volumetric efficiency & clearance.

Explain the scope of the angle radial drilling machine, Scope of  the angl...

Scope of  the angle  radial  drilling  machine  There  are  many  scope  of  the  angle  radial  drilling  machine  like  as:  we  shell produce a hole at any angle with help

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd