Explain about burner management system, Mechanical Engineering

Assignment Help:

Q. Explain about Burner Management System?

The Vendor shall provide a stand alone Burner Management System that is NFPA approved. Provision shall be made for communication with the Buyer's Process Control System. All components shall be rack mounted. All components shall include integral diagnostics. Where a packaged equipment specification covers more than one burner, each burner shall be supplied with its own independent and stand alone Burner Management System.


Related Discussions:- Explain about burner management system

Arc blow, ARC BLOW In certain cases depending upon where the return pa...

ARC BLOW In certain cases depending upon where the return path connections are given for the arc current, the arc may be deflected towards a direction of weaker electro magnet

Design data of screw conveyor with auger, DESIGN FACT DATA: ?A) Torque...

DESIGN FACT DATA: ?A) Torque capacity for traction motor of screw conveyor-1660 N-m. ? B) RPM of Traction motor-115 rpm. ? C) Pressure require for operating the telescopi

Types of coated electrodes-rutile electrode, Rutile Electrode This type h...

Rutile Electrode This type has thicker coating than cellulosic coated and the flux is mainly composed of rutile (titanium di - oxide) and silicates, with a negligible amount of c

Velocity acceleration, velocity acceleration by relative method and intenta...

velocity acceleration by relative method and intentan methodto be showed graphical on it?

Define pattern draft or taper, Q. Define Pattern draft or taper? It is ...

Q. Define Pattern draft or taper? It is also termed as "draw". It is the taper placed on the pattern surface that are parallel to the direction in which the pattern is withdraw

What is isometric drawing, It is a 3-D drawing used by draftsmen, architect...

It is a 3-D drawing used by draftsmen, architects etc

Classification of steam engine , CLASSIFIC A TIO N: (1 )  In acco...

CLASSIFIC A TIO N: (1 )  In accordance to Cylinder Axis: Engine can be vertical or horizontal. (2 )  In accordance to action of steam: Can be single acting or doub

Punches -tool and equipment , Punches Figure: Punches A bar wh...

Punches Figure: Punches A bar which carries a sharp point at one end and used to make a permanent mark on a part is called punch. The point is hard and tempered so tha

Quasistatic loading, • For the ASTM dogbone specimens, the ¾ inch hole spec...

• For the ASTM dogbone specimens, the ¾ inch hole specimens, and the notched specimen tabulate the failure load, in pounds. • Show plots of stress and strain for all specimens w

Safety in tig welding-gaseous and metal fumes hazards, SAFETY IN TIG WELDIN...

SAFETY IN TIG WELDING-Gaseous and Metal Fumes Hazards The major toxic gases associated in TIG welding are ozone, nitrogen dioxide and phosgene gas. Metal fumes are also produced

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd