Determine the origin of step, Mechanical Engineering

Assignment Help:

Determine the Origin of STEP

Considerable progress has been made in vector data exchange over the recent past. Initially, some CAD/CAM vendors offered direct translator software. There are several disadvantages to this approach, which include :

  • A unique pair of translators is needed for every version of every combination of CAD/CAM systems available in the marketplace.
  • The user is dependent on software vendors to maintain this almost infinite combination of version applications.
  • The maintenance of all these combinations of transfer capabilities is costly, and that cost is ultimately passed on to the user.
  • As a general rule, these translators passed low-quality solid geometry that was not adequate for driving NC operations without the CAD/CAM user having to aid the transfer process by doing a lot of geometry clean-up. Also, no attempt was made to transfer parametric model dependencies/constraints.

 


Related Discussions:- Determine the origin of step

Explain the end cutting edge angle, Explain the End Cutting Edge Angle ...

Explain the End Cutting Edge Angle It is an angle between the face of the tool and the plane perpendicular to side of shank. It acts as relief angle that is allows only small s

Bearing materials, Bearing Materials Generally it can be said as a good...

Bearing Materials Generally it can be said as a good bearing material must posse following characteristics as: It must be strong enough to sustain bearing load. It

Frames, Introduction and conclusion on frames

Introduction and conclusion on frames

Define the application of hydrostatic sensor paver machine, Application of ...

Application of Hydrostatic sensor paver machine The Hydrostatic sensor paver machine that is used for lying bituminous Mixed material, roll-down or lean-mixed concrete, track-

Bodies stick together after collision the heat liberated, Two bodies of mas...

Two bodies of mass 1 kg and 2 kg move towards each other in mutually perpendicular direction with velocities 3m/s and 2 m/s respectively. If the bodies stick together after collisi

Turbine, What is the definition of stall

What is the definition of stall

Calculate the magnitudes of the masses, A rotor has the given properties : ...

A rotor has the given properties : If the shaft is balanced by two counter masses located at 100 mm radii and revolving in planes midway of plan 1 and 2 and midway of 3 and

Evaluate elongation of bar of varying cross section, Evaluate elongation of...

Evaluate elongation of bar of varying cross section: How you evaluate elongation of bar of varying cross section:? Sol.: Take bar made up of different lengths and which

What is pressure testing, Q. What is Pressure Testing? Pressure test sh...

Q. What is Pressure Testing? Pressure test shall be performed after completion of all welds and the PWHT of the boiler. Prior to final inspection and pressure test, the insi

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd