Evaluate piston effect, Mechanical Engineering

Assignment Help:

In a double acting vertical steam engine running at speed of 360 r.p.m., cylinder diameter is 25 cm, stroke is 30 cm, diameter of piston rod is about 3.75 cm and length of the connecting rod is 60 cm. When the crank has moved 120o from T.D.C., the pressure of steam at cover end is 35 x 104 N/m2. and at crank end is 3 x 104 N/m2. if the mass of the reciprocating parts is 45 Kg evaluate :

(iv) Piston effect

(v) Turning moment on the crank shaft for the given crank position.


Related Discussions:- Evaluate piston effect

Explain the methodology of hydrostatic sensor pavers machine, Normal 0 ...

Normal 0 false false false EN-IN X-NONE X-NONE MicrosoftInternetExplorer4 Explain the Methodol

Characteristics of adhesives and adhesive joints, Characteristics of Adhesi...

Characteristics of Adhesives and Adhesive Joints While an adhesive joint is created this has to show individual or several of given properties. (a) Mechanical strength again

Mechanical Engineering Careers Incorporating the Outdoors, Are there jobs i...

Are there jobs in the field of Mechanical Engineering that incorporate the outdoors? I am an outdoorsman for one, and a tradesman at heart and am currently a Mechanical engineering

Remove cover left crank case and check for leakage, Remove cover left crank...

Remove cover left crank case and check for leakage: Before attending oil seal leakage check if any leak is there in the highlighted points - Neutral switch "o" ring leak, Shifter

Calculate all the mass-normalised modal vectors, The body, suspension and e...

The body, suspension and engine mounting system of a vehicle may be idealised as a three degree of freedom system consisting of a bar of mass 1400 kg and the centre of mass at G, 1

Characteristics of the secondary circuit, Characteristics of the secondary ...

Characteristics of the secondary circuit The dimensions of the secondary circuit in secondary loop determine to a large extent, the performance of these machines. The secondary

Calculate the tension t in the rope, Calculate the tension T in the rope: ...

Calculate the tension T in the rope: Q: A man raises 10 Kg joist of length 4m by pulling on rope, Find out the tension T in the rope and reaction at point A for the posit

I-Section, An unsymmetrical I-Section as shown in figure below. If maximum ...

An unsymmetrical I-Section as shown in figure below. If maximum bending stress is not extend more than 40MPa in the section than find out the moment which it can bear

What are methods used in rating for time study, a)What are methods used in ...

a)What are methods used in rating for time study. Illustrate them. b) Write down principles of motion economy.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd