Engine oil replacement procedure, Mechanical Engineering

Assignment Help:

Engine oil replacement

Motorcycle is thoroughly drained by kicking the vehicle several times.
Inspect the drain bolt washer and replace if necessary.
Tighten the drain bolt to the specified torque (2-2.5 kg-m).
Engine oil has a great impact on the working and the service life of the engine. So use recommended engine oil only.
If the engine is drained then measure 750-780 ml of engine oil in a clean container and fill in through dipstick hole.
If the engine is disassembled then measure 900 ml of engine oil in a clean container and fill in through dipstick hole.
Tighten the dipstick.

Related Discussions:- Engine oil replacement procedure

Flange bevel and lap ring weld, Q. Flange Bevel And Lap Ring Weld? The ...

Q. Flange Bevel And Lap Ring Weld? The fillet weld attaching the lap ring to the shell shall be an equal leg fillet weld, with the leg dimension equal to the nominal shell thic

Kinematics, derive an expression for range along iclined palne

derive an expression for range along iclined palne

Introduction to advance manufacturing, INTRODUCTION In the morning se...

INTRODUCTION In the morning session there was a discussion about what the teachers are going to do in this week. Later the professor has shown power point presentation on int

Jigs and fixtures, state the purpose and function of work holder

state the purpose and function of work holder

Explain the concept of time dilation, Explain the concept of time dilation....

Explain the concept of time dilation. Describe experimental verification of time dilation. Explain: (i) Length contraction (ii) Time Dilation in STR What are proper length an

Bending stress, What is bending stress? The bending moment at section t...

What is bending stress? The bending moment at section tends to bend or deflect beam and internal stresses resist its bending. The process of bending stops when the cross sectio

Tungsten inclusions, Tungsten Inclusions Tungsten inclusion is a disconti...

Tungsten Inclusions Tungsten inclusion is a discontinuity found only in TIG welding. Particles of tungsten from the electrode can be embedded in a weld when improper welding proc

Symmetric central force, Symmetric Central Force A central force is sph...

Symmetric Central Force A central force is spherically if the magnitude of the force does not depend on the direction (angles θ , or Ø ) of the particle but only on distance

Show space considerations for plant, Q. Show Space Considerations for plant...

Q. Show Space Considerations for plant? There are particular spacing constraints which need particular care and attention when optimizing the layout area utilization in both ne

Introduction to basic troubleshooting of motorcycle , INTRODUCTION: Previo...

INTRODUCTION: Previously, you studied about the repairing some parts of a motorcycle. In this unit, we shall mainly emphasise on the troubleshooting of the basic problems. This un

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages