Explain rate pressure product, Mechanical Engineering

Assignment Help:

Q. Explain Rate Pressure Product?

The systolic blood pressure is multiplied by the heart rate to provide the double product or modified fusion time index. On presence of an obstructed coronary artery it takes a longer time to reach the same pressure pulse value than it would take in a heart with normal coronary arteries.

Because the double product depends on both the SBP and the heart rate, the findings that they appear to be related variables is of some interest.


Related Discussions:- Explain rate pressure product

Determine minimum von mises stress, In this assignment you will apply what ...

In this assignment you will apply what you have learned in previous training. Consider the part in figure, which constructed from a solid tube. The bracket is supported at surface

Find the cycle efficiency, Develop an EES Code for a Rankine cycle with reh...

Develop an EES Code for a Rankine cycle with reheat and with 2 open feedwater heaters.  The cycle is shown below:  Use the following conditions: 1.  700 psi, 850F 2.  500

Determine shear plane angle, The following data was obtained from an orthog...

The following data was obtained from an orthogonal cutting test : Rake angle = 20o, Depth of cut = 6 mm Feed rate = 025 mm/rev Chip length before cutting = 29.4 mm Chip

What is the objective of hydrostatic sensor paver machine, What is the obje...

What is the objective of hydrostatic sensor paver machine To eliminate the problem in screw conveyer extension of hydrostatic sensor paver machine as per screed width" The p

Seasonal-component analysis, Seasonal-Component Analysis: A food proce...

Seasonal-Component Analysis: A food processor uses a moving average to forecast next month's demand. Actual demand data for the past few months is available as depicted in the

The brasses-copper alloys, The Brasses 70/30 brass also called as cart...

The Brasses 70/30 brass also called as cartridge brass contains 70% copper and 30% Zinc. This is employed for cartridge cases, sheet fabrication, and condenser tubes and for u

Ratio of applied stress, Ratio of applied stress: What should be the r...

Ratio of applied stress: What should be the ratio of applied stress, s, to yield stress s Y in a large thin plate so that plastic spread along lint of crack is equal to  1 /1

How to observe water level, Q. How to observe water level? Site for ins...

Q. How to observe water level? Site for installing gauges should be properly selected. The reach should be reasonably straight and of uniform cross· section and slope. The leng

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd