Determine the value of the load resistance, Electrical Engineering

Assignment Help:

Q. A60-Hz, 100-kVA, 2400/240-V(rms) transformer is used as a step-down transformer from a transmission line to a distribution system. Consider the transformer to be ideal.

(a) Find the turns ratio.

(b) What secondary load resistance will cause the transformer to be fully loaded at rated voltage (i.e., delivering the rated kVA), and what is
the corresponding primary current?

(c) Determine the value of the load resistance referred to the primary side of the transformer.


Related Discussions:- Determine the value of the load resistance

Explain open loop control systems, Explain Open Loop Control Systems In...

Explain Open Loop Control Systems In an open-loop control system, the controller independently computes exact voltage or current required by the actuator to do the job and send

Explain the suitability of copper, Explain  the  suitability  of  coppe...

Explain  the  suitability  of  copper that  is  used  as  electrical  conducting materials. Copper : Pure annealed is utilized for the winding of electrical machines. High pur

Explain the working of positive clamper, Q . Explain the working of Positiv...

Q . Explain the working of Positive Clamper? Positive Clamper: The circuit for a positive clamper is shown in the figure. During the negative half cycle of the input signal,

Indicate the condition of the overflow and carry bits, Q. Do the following ...

Q. Do the following operations with 8 bit bytes, and indicate the condition of the overflow and carry bits. a) 10111011 + 00000011 b) 11101101 + 11111001 c) 11011011 + 110

Find the voltage across the 50-resistor, Q. Write and execute a PSpice prog...

Q. Write and execute a PSpice programto analyze the resistor bridge circuit shown in Figure to solve for the node voltages and the voltage-source current. Then find the voltage acr

Explain fourier series, Q. Explain Fourier Series? The phasor method of...

Q. Explain Fourier Series? The phasor method of circuit analysis can be extended (by using the principle of superposition) to find the response in linear systems due to nonsinu

Determine the maximum value of the voltage, Q. Three waveforms seen on an o...

Q. Three waveforms seen on an oscilloscope are shown in Figure. If the horizontal scale is set to 50 ms per division (500 ms for the entire screen width), and the vertical scale is

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd