Determine the rankine efficiency, Mechanical Engineering

Assignment Help:

A simple Rankine cycle works between pressures 0.06 bar and 28 bar, the initial condition of steam being dry saturated. Determine the cycle efficiency, specific steam consumption and work ratio.

In a Rankine cycle, the steam at inlet to turbine is saturated at a pressure of 35 bar and the exhaust pressure is 0.2 bar. Determine:

(i) The pump work,

(ii) The dryness at the end of expansion. Assume flow rate of 9.5 kg/s.

(iii) The condenser heat flow,

(iv) The Rankine efficiency,

(v) The turbine work,


Related Discussions:- Determine the rankine efficiency

Plc, proportional controller for lube oil temperature of engine working dia...

proportional controller for lube oil temperature of engine working diagram

Hydrometer-electrical instruments , Hydrometer: Hydrometer (Figure) is use...

Hydrometer: Hydrometer (Figure) is used to measure the specific gravity of battery fluid (electrolyte). Figure: Hydrometer

Determine the slopes at free end - cantilever beam, Determine the slopes at...

Determine the slopes at free end - cantilever beam: A cantilever beam of length l carries a point load W at a distance l  /4 from free end. Determine the slopes at free end

Steam and power generation equipment, Q. Steam and Power Generation Equipme...

Q. Steam and Power Generation Equipment? Locating steam and power generation equipment outside of the process areas ensures that critical facilities feeding major portions of t

What is raft foundation, What is raft foundation? A raft or mat can be ...

What is raft foundation? A raft or mat can be considered as a combined footing which covers the entire building area and supports all columns and walls. Such a foundation may c

SOM, Torsion of shaft

Torsion of shaft

What is warm extrusion, Q. What is Warm extrusion? • Warm extrusion is ...

Q. What is Warm extrusion? • Warm extrusion is done above room temperature, but below the recrystallization temperature of the material the temperatures ranges from 424 to 975

Calculate composition and microstructure, It is desired to produce an iron-...

It is desired to produce an iron-carbon alloy that has a minimum hardness of 200 HB and a minimum ductility of 35%RA. Is such an alloy possible? If so, what will be its composition

High temperature materials in boilers, Q. High temperature materials in Boi...

Q. High temperature materials in Boilers? A thin refractory layer between the shield and boiler tube is recommended in areas subject to moderate temperatures and levels of corr

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd