Determine the modulation index, Electrical Engineering

Assignment Help:

An angle-modulated signal has the form u(t) = 100 cos [2πfct+4 sin 2πfmt ],where fc =10MHz and fm = 1 kHz. Determine the modulation index
βf or βp and the transmitted signal bandwidth, with BFM = 2(βf +1)fm or BPM = 2(βp +1)fm, (a) If this is an FM signal. (b) If this is a PM signal


Related Discussions:- Determine the modulation index

What do you mean by noise, Q. What do you mean by Noise? In any communi...

Q. What do you mean by Noise? In any communication system there are usually two dominant factors that limit the performance of the system: 1. Additive noise, generated by el

Illustrate working of direct-coupled amplifiers, Q. Illustrate working of D...

Q. Illustrate working of Direct-coupled Amplifiers? Direct-coupled Amplifiers : The following figure shows a direct-coupled amplifier consisting of two stages. A dc voltage i

Why is an emitter bypass capacitor in amplifier, Q.  Why is an emitter bypa...

Q.  Why is an emitter bypass capacitor used in an RC coupled amplifier? If an emitter resistor Re is used for self-bias in an amplifier and if it is desired to avoid the degene

Testing for continuity-earthing, Testing for Continuity : You may have obs...

Testing for Continuity : You may have observed sometimes that when all the connections in the appliance as well as the plug are made properly the appliance may still not work. Thi

Mention the desirable properties of fuse materials, Mention the desirable p...

Mention the desirable properties of fuse materials. A fuse material must possess the properties as follows: Low resistivity - It means, thin wires can be used that will of

Physics, find the resultant of two forces 20N and25N acting at an angle 60...

find the resultant of two forces 20N and25N acting at an angle 60 degree each other

Block diagram of a 4-bit shift-right register using jkffs, Q. A shift regis...

Q. A shift register can be used as a binary (a) divide- by-2, and (b) multiply-by-2 counter. Explain. Q. Show a block diagram of a 4-bit shift-right register using JKFFs.

Principle of three-phase synchronous machines, Q. Principle of Three-phase ...

Q. Principle of Three-phase synchronous machines? In fact, with very few exceptions, three-phase synchronous machines are most commonly used for power generation. In general, t

List the uses of usart, List the uses of USART. USART- Universal Synch...

List the uses of USART. USART- Universal Synchronous Asynchronous Receiver-Transmitters. It is used to transmit and receive the data in serial communication mode. It is

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd